Characterizing and predicting short term performance for the In Salah Krechba field CCS joint industry project

Assessment of carbon dioxide plume behaviour within the storage reservoir and the lower caprock around the KB-502 injection well at In Salah

“…Fig. 5 shows the KB-502 FBHP curves estimated by the JIP and Schlumberger (Pamukcu et al, 2010), respectively, using two different software packages. The Schlumberger FBHP curve is approximately 30 bar lower than the JIP curve -a good match between the two FBHP curves from November 2005 onwards can be obtained if Schlumberger curve is shifted upwards by 30 bar.…”

Suitability of depleted gas reservoirs for geological CO2 storage: A simulation study

“…There have been many studies carried out to show the potential of injecting CO 2 into dry gas and condensate gas reservoirs using numerical modeling techniques. According to these studies, the success of a CO 2 storage practice is linked to the injection strategy, reservoir characteristics, and operational parameters.…”

“…4,5 For instance, the Gorgon Carbon Dioxide Injection project in Australia has been initiated and is in its construction phase for the deployment of CO 2 in a gas field. 6 There have been many studies carried out to show the potential of injecting CO 2 into dry gas [7][8][9][10][11][12][13][14][15] and condensate gas reservoirs 4,[16][17][18][19] using numerical modeling techniques. According to these studies, the success of a CO 2 storage practice is linked to the injection strategy, reservoir characteristics, and operational parameters.…”

Use of low- and high-IFT fluid systems in experimental and numerical modelling of systems that mimic CO2 storage in deep saline formations

“…Parameters used in calculations of dimensionless numbers for existing or planned storage sites (Sleipner, Snøhvit, In Salah, and Gorgon) and for existing test sites (Nagaoka and Ketzin) are obtained from ), Pamukcu et al (2011 and Gor and Prévost (2013). Remaining data was obtained from Bakk et al (2012) for CO2FieldLab, and from Braathen et al (2012) for Longyearbyen CO2 Lab project.…”