Channel prediction in non-regenerative multi-antenna relay selection systems

Abstract

The use of multiple antennas in two-hop amplify-and-forward relay selection is analysed, where the source, relay and destination are each equipped with multiple receive but single transmit antennas. Since relay switching is based upon fed back information which is delay-limited, channel power prediction is employed to mitigate against the effect of outdated channel state information being used to make switching decisions. During transmission, a source selects a best relay on the basis of predicted SNR (signal to noise ratio) over all available links. A chosen relay then employs maximal ratio combining at its receiver, and applies a variable gain to the received signal before forwarding to the destination. Closed form outage probability and bit error rate solutions are found for arbitrary numbers of relays and receive antennas, and used to explore trade offs between number of relays and number of antennas compared to single antenna alternatives. To assess predictor performance in combatting switching delay, comparison is made to non-predictive systems.

Characterisation of relay selection in cooperative multiple‐input multiple‐output‐orthogonal frequency division multiplexing systems

“…As mentioned, we use Gaussian approximation to evaluate the CCDF of the mutual information of the S-R and R-D links. Using (11) and 12, we can obtain the expression (14).…”

“…On the other hand, the cooperative wireless communication is an emerging technique [10][11][12]. Using a cooperative wireless system improves the coverage and the throughput [10].…”