Case Study on Sample Preparation Method to Eliminate the Artifact for Auger Analysis on Bond Pad

Abstract

In today’s advanced technology world, electronic devices are playing a key role in modern semiconductor products to improve the energy proficiency. These devices are required to be contamination free especially on the bond pad with good adhesion before wire bonding process at the back end. Contamination on the bond pad leads to reliability issues such as pad corrosion, delamination and failure leading to leakage and open fails of electronic devices. Therefore, detection accuracy and sensibility of contamination is important. Auger analysis is the most suitable technique to check bond pad contamination. Auger electron spectroscopy has the capability of analyzing compositional information with excellent spatial resolution. However, charging, noise or artifact is known to be a major concern to the characterization of insulating materials. This paper outlines the strategy that has been utilized to minimize the artifact, noise or charging impact for Auger investigation on a smaller bond pad surrounded by imide passivation layers. The imide passivation layer normally causes the charging effect during Auger analysis, which makes the Auger analysis difficult to be proceed. In addition to that, the charging effect leads to inaccurate analysis. In this paper, we demonstrate a sample preparation method to minimize the charging and artifact of Auger analysis especially for small bond pads.