Capacitive electrode sensor implanted on a printed circuit board designed for continuous water level measurement

Abstract

Water level sensors are one of the practical ways to get the actual measurement of the depth of a dam or canal. The ease of deployment and easy data acquisition makes them widely used in many fields. Therefore, it will be advantageous to have a miniaturized water level sensor for easier mobility and deployment. A novel method for measuring water level using a Printed Circuit Board has been proposed in this paper. The design stages of circuit sketching, printing of sketch on PCB and etching are discussed for the electrode water level sensor. A signal conditioning circuit is necessary to maintain a steady flow of current from the power source. The fabricated electrode water level sensor was tested based on its capacitive effect while charging up and the amount of current at each electrode finger at the saturation stage. The hardware enablers for this test were the multimeter and LCR meter. Arduino microprocessor was used to test and measure the transient response time for each electrode finger. The transient response sensitivity of the electrode sensor is measured to be 0.0873 millisecond/cm while the resolution of the electrode sensor is 0.1cm over a range of 30cm water level. A multiple correlation of 0.921 was achieved for the water level, measured current and measured capacitance with P-values less than 0.05 indicating strength of the data obtained from the tests conducted. The result showed strong evidence that the electrode water level sensor can be an alternative method of measuring water level.

IoT-oriented software platform applied to sensors-based farming facility with smartphone farmer app

“…For measuring environmental humidity and temperature, a DHT22 1-Wire sensor was used (Figure 4, Sensing Unit box) with power supply voltage in the range 3.3-6 V, temperature measurement range from -40°C to +80°C and accuracy ±0.5°C, whereas for humidity, range 0%-100% and accuracy ±2%. For detecting soil moisture, the analog SEN0193 capacitive sensor was used (Figure 4, Sensing Unit box); thanks to the anti-corrosive layer that covers the sensing electrodes, it is able to withstand prolonged contact with the ground [21]. It has a power supply range from 3.3V to 5V and operating current of 5mA, providing an output voltage between 0 to 3.3V proportional to soil moisture.…”

Development of Sensors-Based Agri-Food Traceability System Remotely Managed by a Software Platform for Optimized Farm Management

“…WSN nodes are based on programmable microcontrollers and designed as modular structures open both from the hardware and software point of view [ 22 , 23 ]. The sensors used for detecting different environmental and soil parameters have to be carefully chosen; concerning soil water content measure, numerous techniques are currently in use and the suitability of each one depends on cost, accuracy, durability and response time [ 24 ]. A widely used measurement technique is based on the dependence of the dielectric constant with the soil water content that significantly affects the propagation of the electromagnetic waves inside the medium; in fact, the dielectric constant of dry soil is much less than a wet one.…”