Calculation of infrared heating burners of a micronizer using biomethane

Abstract

Studies have been carried out on the purification of biogas from sulfur compounds, carbon dioxide and water vapor for subsequent use in micronizer burners. The possibility of bringing it to the parameters of natural gas of the following composition: methane (CH4) – 85 % vol., carbon dioxide СО2 – 11 % vol., water vapor – 9 mg/m3, hydrogen sulfide H2S - 20 mg/m3 with minimal energy costs for its preparation is demonstrated. The basic relationships are obtained for assessing the design and technological parameters of the infrared radiation burners operation. Experimental studies of the flame stability limits on perforated ceramic nozzles have shown that flashback through them is possible when the thermal power is increased to a certain critical value. In this case, the thermal power depends on the type of gas and the air content in the combustible mixture. The heat balance equations have been derived to optimize the designs and operation modes of infrared radiation burners. The design of 40 gas burners was improved by changing the geometric dimensions and shape for a uniform distribution of biogas supplied and sustainable combustion over the entire area of the burner. It was established that the temperature of the heating surface of the GIK-8 burner on gas mixtures with a CO2 content of 18-34 % is 900-950 ° C, which does not differ from the nominal temperature when operating on natural gas. The infrared heating system was modernized, adapted for burning purified biogas with methane content up to 98 %, in particular, the biomethane feed and control system, the additional biogas input system, and the automatic burner control system were improved.

Study of quality indicators of mixed fodder when using byproducts of the fat-and-oil industry

“…At the same time, the basis of the system of centralized processing of fat and oil raw materials is waste-free technology, its essence is the maximum use of all valuable components of the raw material. According to the assigned task one of the directions of work to attract material resources is the effective use of by-products, which will additionally obtain a new finished product with lower production costs and a sufficiently high quality [2,3,4,6,8,17].…”