Calculation of Electric Field Distribution in the Vicinity of Power Transmission Lines With Towers and Unmanned Aerial Vehicles Presence

Rezinkina, Marina; Sokol, Yevgen; Gryb, Oleg G.; Bortnikov, A.V.; Lytvynenko, Svitlana

doi:10.15407/techned2018.03.003

Cited by 2 publications

(1 citation statement)

References 2 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The finite element method is commonly used in electric field numerical calculation, which has a high application value in solving practical engineering problems [3][4][5]. 3D Finite element electric field simulation is used to calculate the surface field intensity on the fittings of the transmission line and valve hall, in addition, a visible corona test has been also carried out for true fittings, whose results are consistent with the simulation results [6].…”

Section: Introductionmentioning

confidence: 81%

Electrostatic Field Calculation and Structure Optimization of New Shield Ring of 1000 kV Nan-Jing Loop Transmission Line

Zhang

Guanteng

et al. 2020

Trans. Electr. Electron. Mater.

View full text Add to dashboard Cite

Considering the frequent breakage of the hard jumper shield ring in the strain tower of ultra-high voltage alternating current 1000 kV Nan-Jing Transmission Line, the theoretical and experimental studies on new shield ring were carried out in terms of mechanical properties; however, due to the structural changes of shield ring, the field characteristics should be calculated and analyzed. In accordance with the theory that there is no electric field in a metal conductor under electrostatic equilibrium, if there is any metal conductor in the 3D model of the computational domain, there will be no need to subdivide the metal conductor. In this paper, a 3D model load applying method with metal conductors was proposed to calculate the field intensity of Tuned mass damper (TMD) shield ring after improving the mechanical properties of the strain tower, which saved the total number of mesh subdivisions by 48.02%, reduced the computational time by 76.47%, and increased the computational efficiency of 3D numerical electric field. The calculation results validated the correctness and effectiveness of this method. The new TMD shield ring with the field intensity meeting the relevant requirements was adopted in 1000 kV Nan-Jing Loop Transmission Line in December 2016, which has been operating in good condition so far.

show abstract

Section: Introductionmentioning

confidence: 81%