Bending proof strength of Zr61Ti2Cu25Al12 bulk metallic glass and its correlation with shear-banding initiation

Li, Diao-Feng; Shen, Yong; Xu, Jie

doi:10.1016/j.intermet.2020.106915

Cited by 7 publications

(1 citation statement)

References 60 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…However, even if there is a decrease, these values are practically convenient. This suggests that the induced plastic deformation field, elastic stresses, and structural changes are conditioned by the atomic pair ordering and practically relaxed [14]. The development of structural relaxation processes in the selected temperature-time mode during the annealing does not depend on the previous processing of the material.…”

Section: Discussion Of the Workmentioning

confidence: 90%

Prospects to Use Amorphous Fe–Ni–Si–B Ribbons in Contactor Cores

2023

View full text Add to dashboard Cite

We consider the possibility to use an amorphous Fe–Ni–Si–B material in the core of contactors, which are widely used in connecting and disconnecting electric circuits, instead of the crystalline material of 3% electric steel. Alloys containing Fe–Ni–Si–B have been treated with the use of mechanical, thermomechanical, and magnetic fields, and the material for practical applications has been obtained. The processing modes were chosen so that a change in the performance of ferromagnetic (below the Curie temperature) alloys during the annealing could be controlled. The obtained specimens were annealed in oil at 360 ∘C in a magnetic field of 200 A/m for 200 min. The temperature mode was chosen so that the stress relaxation could occur during the annealing, and the structural changes in the material could be observed.

show abstract

Section: Discussion Of the Workmentioning

confidence: 90%