Basic study of aerial flashover characteristics generated from pore of insulating solid

Abstract

This paper reports a study on the possibility of an aerial flashover between a coil conductor and a casing in rotating machines under the application of a lower voltage than Paschen's voltage, even when enough insulation distance is secured. The time lag to aerial flashover originating from surface flashover was measured. To understand the aerial flashover influenced by the parameters of the voltage application circuit, the aerial flashover distance was measured using a cable which had a simulated pore to confirm the above issue. The surface flashover characteristic was also measured using a photomultiplier tube (PMT). It became clear that aerial flashover occurred a few milliseconds after surface flashover generation. After showing the peak, the aerial flashover distance decreased with increasing time constant. The surface flashover time estimated by the PMT output exhibited different values with change of capacitance when the time constant is larger. On the other hand, the average surface flashover current was almost the same in spite of the change of capacitance. From these results, it was concluded that the aerial flashover distance was influenced by the time constant of the circuit.