Avoiding Resistance Limitations in High-Performance Transparent Supercapacitor Electrodes Based on Large-Area, High-Conductivity PEDOT:PSS Films

Abstract

This work describes the potential of thin, spray-deposited, large-area poly­(3,4-ethylenedioxythiophene)/poly­(styrene-4-sulfonate) (PEDOT:PSS) conducting polymer films for use as transparent supercapacitor electrodes. To facilitate this, we provide a detailed explanation of the factors limiting the performance of such electrodes. These films have a very low optical conductivity of σop = 24 S/cm (at 550 nm), crucial for this application, and a reasonable volumetric capacitance of C V = 41 F/cm3. Secondary doping with formic acid gives these films a DC conductivity of σDC = 936 S/cm, allowing them to perform both as a transparent conductor/current collector and transparent supercapacitor electrode. Small-area films (A ∼ 1 cm2) display measured areal capacitance as high as 1 mF/cm2, even for reasonably transparent electrodes (T ∼ 80%). However, in real devices, the absolute capacitance will be maximized by increasing the device area. As such, here, we measure the electrode performance as a function of its length and width. We find that the measured areal capacitance falls dramatically with scan rate and sample length but is independent of width. We show that this is because the measured areal capacitance is limited by the electrical resistance of the electrode. We have derived an equation for the measured areal capacitance as a function of scan rate and electrode lateral dimensions that fits the data extremely well up to scan rates of ∼1000 mV/s (corresponding to charge/discharge times > 0.6 s). These results are self-consistent with independent analysis of the electrical and impedance properties of the electrodes. These results can be used to find limiting combinations of electrode length and scan rate, beyond which electrode performance falls dramatically. We use these insights to build large-area (∼100 cm2) supercapacitors using electrodes that are 95% transparent, providing a capacitance of ∼12 mF (at 50 mV/s), significantly higher than that of any previously reported transparent supercapacitor.

Electrochemical Applications of Two-Dimensional Nanosheets: The Effect of Nanosheet Length and Thickness

“…At higher scan rates the current begins to saturate due to either limitations associated with diffusions of ions 45,71 or the resistance of the electrode. 72 This graph shows clearly that electrodes made from smaller nanosheets result in higher currents. The volumetric capacitance, CV, of the electrodes can be found from the equation:…”

Electrical, Mechanical, and Capacity Percolation Leads to High-Performance MoS2/Nanotube Composite Lithium Ion Battery Electrodes

“…electrode is a greater limiting factor at higher rates 35,65 leaving more scope for improvement on nanotube addition.…”

Production of monolayer-rich gold-decorated 2H–WS2 nanosheets by defect engineering

“…Here the nanosheet concentration of m-WS 2 , m-WS 2 -Au stock and purified m-WS 2 -Au (both with AuCl 3 :WS 2 = 4.5) were adjusted to 0.1 g/L by the addition of water. Equal volumes of the dispersions were deposited (using conditions described elsewhere 50 ) onto pyrolytic carbon substrates. Linear sweep voltammograms were obtained (at 5 mV/s in 0.5 M H 2 SO 4 ) from 0 to −0.6 V vs. a Gaskatel-supplied Hydroflex H 2 -reference electrode.…”