Average Total Hemispheric Emissivity Measurement in the Lwir Spectrum for Adhesive Tapes Used in the Thermography Tape Test

Abstract

Thermographers often use comparative methods to estimate surfaceemissivity. Among the most used is the tape method. In this method a knownemissivity tape in the LWIR (Long Wavelength Infrared) spectrum is placedon the surface to be inspected. After thermal equilibrium, the temperature ofthe tape and the surface under inspection must be the same. In this case, thetemperature observed on the tape is the reference temperature. The emissivityof the surface must then be changed until the reference temperature isreached. It is common practice to admit the value of the emissivity of theadhesive tape as 0.95, there are few studies that present these data withmetrological rigor, which leads to doubts about the emissivity of thecommercial tapes. In this work, experiments were performed on Tekbond,Double A, 3M 101, Rapix, Altape, adhesive tapes for temperatures of 50, 55,60, 65 and 70ºC. An experimental apparatus was developed through which itwas possible to estimate surface reflection, transmission and atmosphericemission for one and two layers of tapes, in order to make emissivitymeasurements possible. Through the data it was possible to statisticallyestimate the LWIR average total hemispheric emissivity as well as theacceptance range to 95% certainty, being therefore equal to ε=0.94±0.03. Itis possible to arm, therefore, that the value of 0.95, usually used as emissivityof the adhesive tape, is extremely reasonable because it is 0.01 of the averagevalue of the Gaussian distribution calculated by this work.