Atomic density effects on temperature characteristics and thermal transport at grain boundaries through a proper bin size selection

Abstract

This study focuses on the proper characterization of temperature profiles across grain boundaries (GBs) in order to calculate the correct interfacial thermal resistance (ITR) and reveal the influence of GB geometries onto thermal transport. The solid-solid interfaces resulting from the orientation difference between the (001), (011), and (111) copper surfaces were investigated. Temperature discontinuities were observed at the boundary of grains due to the phonon mismatch, phonon backscattering, and atomic forces between dissimilar structures at the GBs. We observed that the temperature decreases gradually in the GB area rather than a sharp drop at the interface. As a result, three distinct temperature gradients developed at the GB which were different than the one observed in the bulk solid. This behavior extends a couple molecular diameters into both sides of the interface where we defined a thickness at GB based on the measured temperature profiles for characterization. Results showed dependence on the selection of the bin size used to average the temperature data from the molecular dynamics system. The bin size on the order of the crystal layer spacing was found to present an accurate temperature profile through the GB. We further calculated the GB thickness of various cases by using potential energy (PE) distributions which showed agreement with direct measurements from the temperature profile and validated the proper binning. The variation of grain crystal orientation developed different molecular densities which were characterized by the average atomic surface density (ASD) definition. Our results revealed that the ASD is the primary factor affecting the structural disorders and heat transfer at the solid-solid interfaces. Using a system in which the planes are highly close-packed can enhance the probability of interactions and the degree of overlap between vibrational density of states (VDOS) of atoms forming at interfaces, leading to a reduced ITR. Thus, an accurate understanding of thermal characteristics at the GB can be formulated by selecting a proper bin size. Published by AIP Publishing. [http://dx

Transport Phenomena of Water in Molecular Fluidic Channels

“…In other words, the momentum transfer at the solid-liquid interface is independent of VDOS; the wall-fluid binding energy and adsorbed liquid layer are the crucial factors. This finding differ highly from the case of solid−solid interface, where the overlap between the VDOS regulates the heat transfer 47 . A similar observation has been reported 48 .…”

Viscous heating and temperature profiles of liquid water flows in copper nanochannel

“…1(c). The method has been widely used [7][8][9][10][11][12]. The shear-driven and force-driven flows are enabled by setting the wall a velocity of 50 nm/ns and by setting gravity of 49 m/s 2 .…”

Controlling and Optimizing Entropy Production in Transient Heat Transfer in Graded Materials

“…Experiments where the effective heat conductivity of graded materials is measured through time domain thermo-reflectance, have been addressed with Equations (4)-(6) [23,24]. The thermal resistance in solid-solid and solid-water interfaces has also been studied from the microscopic point of view with nonequilibrium molecular dynamics techniques [25,26].…”