Assessment of thicknesses and color properties of opaque porcelain layers applied by different dental technicians

Pişkin, Bülent; Sipahi, Cumhur; Ayyıldız, Simel; Günay, Yumuşhan

doi:10.5455/gulhane.152766

Cited by 3 publications

(1 citation statement)

References 27 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…An opaque porcelain (OP) layer with a thickness of 0.2 mm was obtained. After the OP application was completed, the OP thicknesses were measured with the Würth Dual ultrasonic measuring device (UMD) (Adolf Würth GmbH, Künzelsau, German) (Figure 1D) as stated by Pişkin et al (17). Calibration was done according to the device's foil standards.…”

Section: Methodsmentioning

confidence: 99%

Metal-Seramik Diş Restorasyonlarının Üretiminde Farklı Yüzey İşlemlerinin Makaslama Bağlanma Dayanımına Etkilerinin Araştırılması

Kara

2022

Sağlık Bilimlerinde Değer

View full text Add to dashboard Cite

Aim:The bond strength between metal and porcelain is an essential factor for the success of metal-ceramic restorations. Therefore, this study evaluated the shear bond strength (SBS) between ceramic and cobalt-chromium (Co-Cr) alloys after oxidation treatment. Material and Methods: A total of 150 Co-Cr samples, 50 samples each, were produced from casting, laser sintering, and milling techniques. The primary group samples produced were divided into five subgroups. One of the subgroups is sandblasted with 110 µm Al2O3, and the others are ground with carbon separator disc, sintered diamond bur, tungsten carbide bur, and pink stone in one direction. SBS test was applied after the oxidation and veneering process. After debonding, digital microscopy investigated the surface characterizations of Co-Cr alloys. For the normality distribution of SBS measurements, the Kolmogorov-Smirnov test was used. According to the results, non-parametric tests were used in the study because the distribution was not suitable for the normal distribution, and the number of samples within the group was low in the subgroups. Kruskal Wallis and All pair-wise post hoc test (α = 0.05) were used for analysis. Results: There was a statistical difference between the laser sintering and milling groups according to the fabrication techniques. The highest SBS value was found in the Al2O3 laser group (34.35) and the lowest in the Al2O3 casting group (17.68). Surface treatments significantly altered ceramic adhesion. Almost all subgroups exhibited mixed failure. All of the SBS values found in this study were almost clinically acceptable. Conclusion: As different abrasives in the leveling and finishing of metal substructures may affect the metal-ceramic bonding, care should be taken in their use as much as possible.

show abstract

Section: Methodsmentioning

confidence: 99%