Assembly of graphene oxide on nonconductive nonwovens by the synergistic effect of interception and electrophoresis

Microstructure and photocatalytic activity of electrospun carbon nanofibers decorated by TiO 2 nanoparticles from hydrothermal reaction/blended spinning

“…In the hydrothermal reaction pathway, in order to obtain high loading amount PAN@TiO 2 nanofibers, PEG was added into the spinning solution to obtain rough PAN fibers (Fig. S3) owing to the low surface energy and poor adhesion property of PAN nanofibers [33]. The preparation process of rough PAN fibers could be seen in nanoparticles changed from large to small with further elevating heat treatment temperature.…”

Facile and green fabrication of cellulosed based aerogels for lampblack filtration from waste newspaper

“…As shown in Fig.8, all CAGs exhibited better filtration performance than PP nonwovens in term of filtration efficiency (%). CAG2 showed a (Jiao et al, 2015;Li, Wang, Zhang, & Wei, 2014). robustness, hydrophobic, and oleophilic properties.…”

Fabrication of a multifunctional graphene/polyvinylphosphonic acid/cotton nanocomposite via facile spray layer-by-layer assembly

“…44 XRD diffraction patterns, together with the calculated parameters for the untreated cotton, cotton coated with polyvinyl phosphonic acid and graphene/polyvinylphosphonic acid/cotton nanocomposites, are shown in Fig. 5 12,17,45 Researchers have found that graphene peaks are not detectable on coated textiles if successful exfoliation and uniform assembly is achieved. On a similar note, we also calculated the crystallinity percent and crystal size of the cellulose aer coatings according to eqn (1).…”

“…Similar results have been reported elsewhere for graphene coatings over cotton, polyester and polypropylene bers. 12,17,45 Researchers have found that graphene peaks are not detectable on coated textiles if successful exfoliation and uniform assembly is achieved. On a similar note, we also calculated the crystallinity percent and crystal size of the cellulose aer coatings according to eqn (1).…”