Array of Resonant Electromechanical Nanosystems: A Technological Breakthrough for Uncooled Infrared Imaging

Abstract

Microbolometers arethe most common uncooled infrared techniques that allow 50 mK-temperature resolution to be achieved on-scene. However, this approach struggles with both self-heating, which is inherent to the resistive readout principle, and 1/f noise. We present an alternative approach that consists of using micro/nanoresonators vibrating according to a torsional mode, and whose resonant frequency changes with the incident IR-radiation. Dense arrays of such electromechanical structures were fabricated with a 12 µm pitch at low temperature, allowing their integration on complementary metal-oxide-semiconductor (CMOS) circuits according to a post-processing method. H-shape pixels with 9 µm-long nanorods and a cross-section of 250 nm × 30 nm were fabricated to provide large thermal responses, whose experimental measurements reached up to 1024 Hz/nW. These electromechanical resonators featured a noise equivalent power of 140 pW for a response time of less than 1 ms. To our knowledge, these performances are unrivaled with such small dimensions. We also showed that a temperature sensitivity of 20 mK within a 100 ms integration time is conceivable at a 12 µm pitch by co-integrating the resonators with their readout electronics, and suggesting a new readout scheme. This sensitivity could be reached short-term by depositing on top of the nanorods a vanadium oxide layer that had a phase-transition that could possibly enhance the thermal response by one order of magnitude.

Nanoelectromechanical infrared detector

“…The thermal response time of the SiN drum detector was analysed by the "90/10 method". 26 Therefore the rise time was extracted from a step signal taking the temporal difference were 10 and 90 percent of the frequency shift are reached, as shown in figure 5b). The fall time of τ r = 35 ms results in a response time corresponding to a first order low-pass filter of τ = τ r /ln(9) = 17 ms.…”

A Chopper Stabilization Audio Instrumentation Amplifier for IoT Applications

“…The control loop comprises an adder that extracts the common-mode voltage of the bridge, a subtractor S1, an integrator I1, and a generator controlling the voltage VN. The voltage Verror is the error voltage that can be written as: (4) At equilibrium, Verror = 0 V, then:…”

“…For decades until today, MEMS sensors have been manufactured on a large scale for many consumer applications such as aerospace [1], inertial sensors in mobile phones such as gyrometers and accelerometers [2,3], video game controllers and airbag triggers. These devices, which are the basis of research tools [4], have reached a sufficient maturity to be directly developed and integrated by large industrial groups such as STMicroelectronics [5].…”

A 5-nV/√Hz Chopper Negative-R Stabilization Preamplifier for Audio Applications

“…For decades, and still today, MEMS sensors have been manufactured on a large scale for many consumer applications, such as aerospace [1]; inertial sensors in mobile phones, such as gyrometers and accelerometers [2,3]; video game controllers; and airbag triggers. These devices, which are the basis of research tools [4], have reached a sufficient maturity to be directly developed and integrated by large industrial groups, such as STMicroelectronics [5].…”