Application of Combined Electric Arc Coatings for Parts and Units of Vehicles Recovery in Repair Technologies

Ahieiev, Maksim; Грицук, Ігор; Litikova, Aleksandra; Bilousov, Ievhen; Vrublevskyi, Roman; Boboshko, Oleksandr; Smyrnov, Oleg; Saraieva, Iryna; Khudiakov, Igor; Pohorletskyi, Dmytro

doi:10.4271/2021-01-5100

Cited by 2 publications

(1 citation statement)

References 17 publications

Supporting

Mentioning

Contrasting

Unclassified

Order By: Relevance

“…Анализ существующих технологий восстановления поршневых пальцев ДВС показал, что данные способы восстановления поршневых пальцев в ряде случаев отличаются сложностью процесса, низкой производительностью, значительными расходами тепловой и электрической энергии [1,8,12,13,17,18,19,20]. Ни один из существующих способов не является универсальным и по различным причинам неприменим для восстановления всех видов поршневых пальцев.…”

Section: Introductionunclassified

Electric discharge process modelling when piston pins recovery in internal combustion engines

Savenko,

Matvienko

et al. 2024

Vestn. SibADI

View full text Add to dashboard Cite

Introduction. The relevance of the topic of the presented article is determined by the improvement of the technology for repairing and restoring machine parts. Currently, the technology of restoring piston pins of internal combustion engines (ICE) by a high-energy method of plastic deformation of metal using the energy of a high-voltage pulse discharge in a liquid is widely used – the electrohydraulic effect, and on its basis electrohydraulic processing. The purpose of the article is to increase the efficiency of the method of restoring piston pins of internal combustion engines due to the use of the electrohydraulic distribution method.Materials and methods. The research methods such as the analysis of the degree of influence of the electrical parameters of the electrohydraulic distribution process on the amount of deformation of the piston fingers depending on the relevant material were used. The article discusses a mathematical model of the electric discharge process when restoring piston pins. The calculation method determines the modes and parameters of the process of electrohydraulic distribution of piston pins while maintaining their fatigue life, static strength and wear resistance.Results. In this work, the degree of influence of the electrical parameters of the electrohydraulic distribution process on the amount of deformation of the piston pins, depending on the product material used, is established. A mathematical model of the electric discharge process during the restoration of piston pins has been developed, and based on them, the modes and parameters of the process of electrohydraulic distribution of piston pins have been determined while maintaining their fatigue life, static strength and wear resistance.Discussion and conclusions. The studies have shown that exploding wires made of iron, copper, and tungsten are not effective in restoring piston pins with an internal radius of up to 10 mm. The pressure in the case of their use does not exceed 100 MPa. Exploding Al wires with a diameter of less than one millimeter have the greatest effect. In this case, the inductance of the circuit should be minimal, because this provides the largest share of the energy released in the discharge channel from all stored in the capacitor. This ensures the highest pressure in the channel. Based on the same considerations, the capacity should be limited to a range of 3-12 UF. This method can be applied to the restoration of other car parts.

show abstract

Section: Introductionunclassified