Application of an energy source power system stabilizer on the 10 MW battery energy storage system at Chino substation

Bhargava, B.; Dishaw, G.

doi:10.1109/59.651626

Cited by 65 publications

(27 citation statements)

References 3 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In fact, theoretical research and laboratory experiment have demonstrated that SMES, as one of typical ESS applied in power systems, can effectively suppress power system oscillations [11]. Field application has also shown that battery ESS can provide damping to power system oscillations and enhance system stability [12]. VSC based FACTS devices and ESS are set up on DC bus and connected to power transmission network via an interface of inverter.…”

Section: Introductionmentioning

confidence: 99%

Damping torque analysis for DC bus implemented damping control

Wang

et al. 2009

Int Trans Elec Energy Syst

View full text Add to dashboard Cite

show abstract

Section: Introductionmentioning

confidence: 99%

Damping torque analysis for DC bus implemented damping control

Wang

et al. 2009

Int Trans Elec Energy Syst

View full text Add to dashboard Cite

show abstract

“…In some conditions that request output DC voltage be lower than power supply, we need a Bucktyped circuit. Or else it's difficult to realize the design of rectifier [5]. CSI offers a steady DC current.…”

Section: Converter Structure and Work Theorymentioning

confidence: 99%

“…In the literature [5], the inherent transfer sector of inner loop system can be thought to inertia sector. In order to set inner loop system to 1 system, we regulate the inner loop by integrating device.…”

Section: The Design Of Current Inner Control Loopmentioning

confidence: 99%

Control System Design of CSI Applied in the Battery Pack Testing System

Zhang¹,

Kang²,

Rugang³

2010

SGRE

View full text Add to dashboard Cite

show abstract

“…Battery energy storage systems 1 can be installed at ESs for load leveling and relay protection. 2 If faults occur in ESs, their battery energy storage systems can continually supply electric power for their output. Nevertheless, the electric power supply is temporary because the capacities of battery energy storage systems are limited.…”

Section: Introductionmentioning

confidence: 99%

A supervisory control strategy for the detection and restoration of power transmission failures during peak periods using Petri nets

Jiang

Chen

Tang

2017

Advances in Mechanical Engineering

View full text Add to dashboard Cite

As the important infrastructure of power transmission systems, the power transmission lines are vulnerable during the peak power transmission periods. They usually meet many faults that may cause large area blackouts because of heavy loads. This article proposes a supervisory control strategy to promote the detection and restoration of power transmission failures during the peak or off-peak periods. The faults occurring in power transmission lines can be detected, and fault restoration schemes can be selected by supervisors. Moreover, the architecture of distributed control systems is proposed to perform message switching among supervisors. A coordination protocol that is executed by each supervisor is proposed to selected fault restoration schemes. The proposed strategy can not only detect and restore power transmission failures but also improve the utilization rate of available loads in power transmission systems. The proposed distributed control systems and coordination protocol are modeled by synchronized Petri nets. The correctness of fault restoration is verified using the mathematical methods of Petri nets. Finally, the complexity of the proposed distributed control systems and coordination protocol is discussed, and a real-world example is given.

show abstract

Application of an energy source power system stabilizer on the 10 MW battery energy storage system at Chino substation

Cited by 65 publications

References 3 publications

Damping torque analysis for DC bus implemented damping control

Damping torque analysis for DC bus implemented damping control

Control System Design of CSI Applied in the Battery Pack Testing System

A supervisory control strategy for the detection and restoration of power transmission failures during peak periods using Petri nets

Contact Info

Product

Resources

About