Anisotropy of Photopolymer Parts Made by Digital Light Processing

Abstract

Digital light processing (DLP) is an accurate additive manufacturing (AM) technology suitable for producing micro-parts by photopolymerization. As most AM technologies, anisotropy of parts made by DLP is a key issue to deal with, taking into account that several operational factors modify this characteristic. Design for this technology and photopolymers becomes a challenge because the manufacturing process and post-processing strongly influence the mechanical properties of the part. This paper shows experimental work to demonstrate the particular behavior of parts made using DLP. Being different to any other AM technology, rules for design need to be adapted. Influence of build direction and post-curing process on final mechanical properties and anisotropy are reported and justified based on experimental data and theoretical simulation of bi-material parts formed by fully-cured resin and partially-cured resin. Three photopolymers were tested under different working conditions, concluding that post-curing can, in some cases, correct the anisotropy, mainly depending on the nature of photopolymer.

Understanding and Improving Mechanical Properties in 3D printed Parts Using a Dual‐Cure Acrylate‐Based Resin for Stereolithography

“…Thus, the final printed properties remain inferior to those of the fully converted material (Figure 2). [3,13–15] The latter has been studied using epoxy-based resins, but these require higher energies for photo-polymerization than acrylate-based resins, leading to increased print times. [12] These approaches do not address the root cause of mechanical inferiority, and achieving equivalent material properties in 3D printed parts remains challenging.…”

Concurrent Modelling and Experimental Investigation of Material Properties and Geometries Produced by Projection Microstereolithography

“…Monzón et al [28] studied the effect of post-curing on the anisotropy of the manufactured parts. The results showed that with proper post-curing time, the anisotropy diminishes completely along all axes with a notable increase in the mechanical strength.…”

Functionally graded additive manufacturing to achieve functionality specifications of osteochondral scaffolds

“…For example, in the group of Vat photopolymerization is well known the Digital Light Processing (DLP), which is based on an array of micro-mirrors (moved by micro-actuators) suitable to be oriented into two positions. The UV light is reflected by these micro-mirrors to the layer of liquid photopolymer, curing each layer like a unique mask [20]. The resolution of the cured mask is defined by the number of pixels.…”