Analytical evaluation of DC capacitor RMS current and voltage ripple in neutral-point clamped inverters

Abstract

The sizing of the DC-link capacitor in a three-level inverter is based on the RMS current flowing through it. This paper analyses the DC-link capacitor RMS current in a neutral-point clamped (NPC) inverter and expresses the same as a function of modulation index, line-side current amplitude and power factor. Analytical closed-form expressions are derived for the capacitor RMS current for single-phase half-bridge, single-phase full-bridge and three-phase three-leg topologies of a three-level inverter. The worst-case capacitor current stress is determined for each topology based on the analytical expressions. Further, analytical expressions are derived for the RMS values of low-frequency and high-frequency capacitor currents. These expressions are then used to estimate voltage ripple across the DC capacitor for sinusoidally modulated three-phase NPC inverter. The analytical expressions for the RMS current and voltage ripple are validated experimentally over a wide range of operating points. Keywords. Current control; current stress; diode-clamped inverter; full-bridge inverter; half-bridge inverter; multi-level inverter; proportional-resonant controller; sinusoidal modulation; vector control; voltage ripple.

Failure Modes and Reliability Oriented System Design for Aerospace Power Electronic Converters

“…The RMS current through the DC link capacitors is required to estimate the thermal stress applied on capacitors. The DC link capacitor rms current is evaluated as reported in literature for 2L converter topology [40] and 3L-NPC topology [41]. The necessary variables for rms current calculation is also available in the lookup table.…”

Design and Analysis of a High-Efficiency All-SiC Dynamic Voltage Restorer for Wide-Range Sag/Swell Mitigation

“…According to [18], the rms value of the capacitor rms current 𝐼𝐼 𝑐𝑐ℎ,𝑟𝑟𝑟𝑟𝑠𝑠 for a three-phase, three-level inverter can be derived from…”

Reliability Analysis of aircraft starter generator drive converter

“…Hence the rms current through the capacitor would yiled the loss figure that can be fed into the thermal network to yield the capacitor hot spot temperature. An equation to derive rms current through DC link capacitors for a 3L-NPC converter is derived in [9].…”