Analysis of seismic site characterization of the Isparta basin (southwestern Turkey) using passive surface-wave method (ReMi™) and borehole data

Silahtar, Ali; Kanbur, Zakir; Beyhan, Günay

doi:10.1007/s12040-019-1310-7

Cited by 4 publications

(1 citation statement)

References 20 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In this study, multi-channel analysis of surface wave (MASW) [46] and refractionmicrotremor (ReMi) [47] methods were used at 40 data measurement locations (Figure 2). Both techniques are widely used to reveal the geotechnical features of the ground [48][49][50]. MASW was used with an active source in this study, while ReMi was used with a passive source.…”

Section: Surface Wave Data Acquisitionmentioning

confidence: 99%

Site Characterization and Liquefaction Hazard Assessment for the Erenler Settlement Area (Sakarya Province, Turkey) Based on Integrated SPT-Vs Data

2023

Self Cite

View full text Add to dashboard Cite

The focus of this study is to examine the soil properties and liquefaction potential of the Erenler center district in a critical tectonic zone that can produce large earthquakes, such as the North Anatolian Fault Zone (NAFZ). In this sense, 40 surface wave measurements and 52 geotechnical drillings were employed. Accordingly, the liquefaction potential index (LPI), liquefaction severity index (LSI), Ishihara boundary (IB) curve, and Ishihara-inspired index (LPIISH) liquefaction approaches from geotechnical and geophysical methods were used as integrated. All liquefaction analyses were examined for two scenarios, Mw: 7.4 1999 Izmit (amax: 0.41 g) and Mw: 7.0 1967 (amax: 0.28 g) Mudurnu. According to the analyses, almost all of the study area showed liquefaction risk in the Izmit scenario. In the Mudurnu scenario, liquefaction risk distribution decreased parallel to acceleration. The LPI, LPIISH, and IB liquefaction risk results for both scenarios support each other. On the other hand, it was determined that the probability of liquefaction was lower in the LSI evaluation. The spatial distribution of the liquefaction potential of the Vs-based and SPT-based LPI assessments had a similar pattern. These results show that the LPI approach, originally SPT-based, can also be calculated based on Vs. In addition, according to Vs30-based (average shear wave velocity at 30 m depth) soil classification criteria, low-velocity character E and D soil groups dominate the Quaternary alluvial basin. This indicates that deformation-induced failures may occur even in areas with a low probability of liquefaction in similar strong ground motions. In addition, the evaluation of liquefaction with many approaches in two different bases within the scope of the study constitutes a novelty for the study area and liquefaction analyses. While performing diversified liquefaction analyses and approaches will contribute to obtaining more reliable soil liquefaction results, more case studies are needed to elucidate these comparisons.

show abstract