Analysis of Electrokinetic Mixing Using AC Electric Field and Patchwise Surface Heterogeneities

Abstract

In this paper, the authors investigate the use of an applied AC electric field and microchannel surface heterogeneities to carry out the microfluidic mixing of two-dimensional, time-dependent electroosmotic flows. The time-dependent flow fields within the microchannel are simulated using the backwards-Euler time-stepping numerical method. The mixing efficiencies obtained in microchannels with two different patchwise surface heterogeneity patterns are investigated. In general, the results show that the application of an AC electric field significantly reduces the required mixing length compared with the use of a DC electric field. Furthermore, the presence of oppositely charged surface heterogeneities on the microchannel walls results in the formation of localized flow circulation regions within the bulk flow. These circulation regions grow and decay periodically in accordance with the periodic variation of the AC electric field intensity and provide an effective means of enhancing species mixing in the microchannel. Consequently, the use of an AC electric field together with patchwise surface heterogeneities permits a significant reduction in both the mixing channel length and the retention time required to attain a homogeneous solution.

Aspect Ratio Effect on Multiple Flow Solutions in a Two-Sided Parallel Motion Lid-Driven Cavity

“…This standard problem is then solved by a restarted, iterative Arnoldi method, which is essentially a sophisticated extension of the power iteration method, and which allows a number of eigenvalues,  , of largest magnitude to be calculated via ARPACK (Saad [19]). For the detailed algorithm of the linear stability analysis, one can refer to the studies of Yang and Luo [20], Luo et al [21] and Chen et al [13].…”

Electrokinetic Instability Induced Valveless Multi-Switching in a Microfluidic Chip

“…Temporal profiles of the switching process were obtained using a detection system similar to that presented by Alarie et al [4]. The details of the measurement principle are presented in the literature [5], and hence the operating process is described only briefly in the following: (1) the sample was introduced into the inlet channel via the application of an electrical potential to the sample inlet channel, [6][7] (2) the same electrical potential was applied to each of the focusing channels in order to generate sheath flows to focus the sample into a narrow stream, and (3) the outlet channels were electrically isolated or grounded, as appropriate, in order to drive the focused sample flow electrokinetically to the required outlet port. The present microfluidic chip was fabricated on glass substrates using standard photolithography and wet chemical etching techniques.…”

Research for a Non-Standard Kenics Static Mixer with an Eccentricity Factor

“…Fluid mixing schemes can be divided into either "active", where external forces drive fluid movement, like electric field perturbations [1,2] and mechanical agitation [3], or "passive", where the contact area and contact time of the species samples are increased through specially designed inserts, like a static mixer [4] and modified wall [5,6]. A static mixer is an efficient mixing device that incorporates continuously repeating elements in the pipeline and influences the fluid flow during the process, intensifying the mass and heat transfer [7].…”