Analysis Design and Development of Regulated Power Supply-Using Soft Switched Resonant Converters

Padmanabhan, Sampath Kumar; Sukhi, Y.; Jeyashree, Y.

doi:10.3923/jas.2007.3530.3535

Cited by 2 publications

(1 citation statement)

References 2 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…[7] used LM317 to design and construct a portable cheap DC regulated power supply for experiments in Physics college laboratory. [8] Analysed a high frequency link series-parallel resonance converter using AC complex analysis. [4] Analysed the current problems of power supply monitoring equipment in transmission line, illustrates the application limit of photovoltaic panels power currently used in the design of a new type of power supply.…”

Section: Introductionmentioning

confidence: 99%

Design and construction of a DC – DC power supply for powering USB soldering iron

Yusuf,

Shehu,

Musa

et al. 2023

CaJoST

View full text Add to dashboard Cite

Power supply is an electrical device that converts electric current from a source to the desired voltage, current and frequency to power an electrical load. The universal serial bus (USB) soldering iron available in the market operates on a 5-volt direct current (DC) supply. Essentially, it can be powered by any cell phone charger that is capable of providing an output power of not less than 8 watts. Absence of constant power supply from the national grid at times inhibit effective use of this soldering iron. To power it directly from storage battery is inappropriate as most batteries are rated as 2.7, 3.7, 6, and 12 volts. This paper deals with the design and construction of an inexpensive portable regulated power supply to power a USB soldering iron from a 12 volt power supply. The circuit was designed and simulated using Proteus software “intelligent schematic input system (ISIS)” before the construction procedure. Deep discharge protection that safeguard storage battery against under voltage and reverse polarity protections were added to the design. These special features distinguished it from those available in the market. Two light emitting diodes (LED) serve as indicators for low and normal condition of battery while sound from a buzzer shows that the input terminals of the circuit were wrongly connected. The system was tested and found to work as anticipated.

show abstract

Section: Introductionmentioning

confidence: 99%