2017
DOI: 10.1002/nbm.3690
|View full text |Cite
|
Sign up to set email alerts
|

An indirect method for in vivo T2 mapping of [1‐13C] pyruvate using hyperpolarized 13C CSI

Abstract: An indirect method for in vivo T mapping of C-labeled metabolites using T and T * information of water protons obtained a priori is proposed. The T values of C metabolites are inferred using the relationship to T ' of coexisting H and the T * of C metabolites, which is measured using routine hyperpolarized C CSI data. The concept is verified with phantom studies. Simulations were performed to evaluate the extent of T estimation accuracy due to errors in the other measurements. Also, bias in the C T * estimatio… Show more

Help me understand this report

Search citation statements

Order By: Relevance

Paper Sections

Select...
3
1
1

Citation Types

0
12
0

Year Published

2018
2018
2021
2021

Publication Types

Select...
5

Relationship

0
5

Authors

Journals

citations
Cited by 7 publications
(12 citation statements)
references
References 20 publications
0
12
0
Order By: Relevance
“…Finally, in these initial studies, the total readout time for each slice was 9.9 ms for prostate studies and 16.5 ms for brain studies. Although this resulted in short echo‐spacing and made the acquisitions more robust to B 0 inhomogeneity, we anticipate that the SNR could readily be improved by increasing the total readout duration, given the relatively long T 2 * of 13 C substrates . However, this will place more of a burden on shimming and frequency calibration, as a further increase in echo‐spacing would make the acquisition more susceptible to geometric distortion and bulk shifts in the blip dimension.…”
Section: Discussionmentioning
confidence: 99%
See 1 more Smart Citation
“…Finally, in these initial studies, the total readout time for each slice was 9.9 ms for prostate studies and 16.5 ms for brain studies. Although this resulted in short echo‐spacing and made the acquisitions more robust to B 0 inhomogeneity, we anticipate that the SNR could readily be improved by increasing the total readout duration, given the relatively long T 2 * of 13 C substrates . However, this will place more of a burden on shimming and frequency calibration, as a further increase in echo‐spacing would make the acquisition more susceptible to geometric distortion and bulk shifts in the blip dimension.…”
Section: Discussionmentioning
confidence: 99%
“…Although this resulted in short echo-spacing and made the acquisitions more robust to B 0 inhomogeneity, we anticipate that the SNR could readily be improved by increasing the total readout duration, given the relatively long T 2 * of 13 C substrates. 30 However, this will place more of a burden on shimming and frequency calibration, as a further increase in echo-spacing would make the acquisition more susceptible to geometric distortion and bulk shifts in the blip dimension. In this case, alternating the blip polarity each time frame 31 or using a dual-echo EPI acquisition 32,33 could potentially be used to correct for distortion and signal loss arising from B 0 inhomogeneity.…”
Section: Discussionmentioning
confidence: 99%
“…Blurring arising from T2*-related signal decay will ultimately limit the echo train length. Given that the in vivo T2* values are on the order of 20–100 ms at 3 T [27], readout durations on the order of 20–40 ms should be achievable without substantial resolution loss. While T2 has been reported to be substantially longer than T2* for 13 C substrates [28,29], spin echo approaches [30,31] are problematic for hyperpolarized studies because miscalibration of the B 1 power and B1+ inhomogeneity can lead to rapid RF decay from the refocusing pulses due to saturation at the edge of the coil [32].…”
Section: Discussionmentioning
confidence: 99%
“…The digital phantom was designed as a replica of the physical phantom and simulated with an 8° tilt along the z‐axis (see Supporting Information Figure ). The following relaxation parameters were used in the simulation: T 1 = 1000 ms; T 2 = 200 ms; and T2* = 50 ms (simulating T2* properties of pyruvate) . The simulation was performed with a ±15 Hz macroscopic off‐resonance distribution and hard pulse singlet excitation.…”
Section: Methodsmentioning
confidence: 99%
“…The following relaxation parameters were used in the simulation: T 1 = 1000 ms; T 2 = 200 ms; and T * 2 = 50 ms (simulating T * 2 properties of pyruvate). 24 The simulation was performed with a ±15 Hz macroscopic off-resonance distribution and hard pulse singlet excitation. Off-resonance effects of the SPSP excitation were therefore not simulated.…”
Section: Simulationsmentioning
confidence: 99%