An in vitro test bench reproducing coronary blood flow signals

Abstract

BackgroundIt is a known fact that blood flow pattern and more specifically the pulsatile time variation of shear stress on the vascular wall play a key role in atherogenesis. The paper presents the conception, the building and the control of a new in vitro test bench that mimics the pulsatile flows behavior based on in vivo measurements.MethodsAn in vitro cardiovascular simulator is alimented with in vivo constraints upstream and provided with further post-processing analysis downstream in order to mimic the pulsatile in vivo blood flow quantities. This real-time controlled system is designed to perform real pulsatile in vivo blood flow signals to study endothelial cells’ behavior under near physiological environment. The system is based on an internal model controller and a proportional-integral controller that controls a linear motor with customized piston pump, two proportional-integral controllers that control the mean flow rate and temperature of the medium. This configuration enables to mimic any resulting blood flow rate patterns between 40 and 700 ml/min. In order to feed the system with reliable periodic flow quantities in vivo measurements were performed. Data from five patients (1 female, 4 males; ages 44–63) were filtered and post-processed using the Newtonian Womersley’s solution. These resulting flow signals were compared with 2D axisymmetric, numerical simulation using a Carreau non-Newtonian model to validate the approximation of a Newtonian behavior.ResultsThis in vitro test bench reproduces the measured flow rate time evolution and the complexity of in vivo hemodynamic signals within the accuracy of the relative error below 5%.ConclusionsThis post-processing method is compatible with any real complex in vivo signal and demonstrates the heterogeneity of pulsatile patterns in coronary arteries among of different patients. The comparison between analytical and numerical solution demonstrate the fair quality of the Newtonian Womersley’s approximation. Therefore, Womersley’s solution was used to calculate input flow rate for the in vitro test bench.

Determination of hemodynamic risk for vascular disease in planar artery bifurcations

“…Eight different configurations of symmetric Y-junction vessels were studied with angles ranging from 25° up to 180°. For the simulations here presented, an inlet velocity condition consisting in a flat profile of 0.2 m/s 21 was considered in the main vessel and atmospheric pressure outlet in both branching vessels, except specified otherwise. Although it is well known that there are other outflow conditions more suitable to correlate simulations with real circulatory system (such as Murray law-based conditions) an atmospheric pressure condition was used as a first approximation to the problem in order to compare the experimental data.…”

The impact of arterial flow complexity on flow diverter outcomes in aneurysms

“…Briefly, the experiments were carried out using the spherical transparent silicone model placed in the in vitro test bench developed previously 19 . The test bench was set at 37 °C.…”

“…In this article, the impact of harmonic flow complexity on flow diverter treatment of intracranial aneurysms was investigated experimentally using an in vitro analysis. For this purpose, a silicone model of a spherical aneurysm was connected to a test bench mimicking the pulsatile haemodynamic conditions encountered in vivo 19 . For the input flow signal, the flow from a reference patient was decomposed into four patterns with decreasing complexity and pulsatility indexes.…”

Active Pneumatic Pulsation Damper for Peristaltic Pump Flow Loops

“…Gear pumps cause significant noise in the flow and pressure signal and should not be used for studies with blood cells. In [13][14][15] a centrifugal pump is used to provide the baseline flow because of its low noise signature compared to a roller pump. A piston pump superposes the pulsatile flow.…”