An Improvement in Constrained Studded Pressing for Producing Ultra-Fine-Grained Copper Sheet

Abstract

In this study, constrained studded pressing (CSP) was modified to produce ultra-fine-grained copper sheets and is called modified-CSP. In modified-CSP, due to the selection of asymmetric semicircle studs, the maximum groove depth can increase up to three times the sheet thickness. In the CSP method, the groove depth is selected to be equal to the sheet thickness. To investigate the effective plastic strain, a finite element model (FEM) of modified-CSP was established. For this purpose, DEFORM-3D commercial software was used. A simulation showed that the modified-CSP process was capable of using higher strain, about 0.8 in each pass than in CSP. Copper sheets were deformed up to 10 passes by modified-CSP. The microstructure of the produced samples was analyzed. The results show that the grain size decreases in the first pass. In addition, with increasing plastic strain, the structure of the twins bands was observed. Mechanical properties, including tensile properties and Vickers microhardness, of the samples during the process were investigated. The strain inhomogeneity factor (SIF) and the hardness inhomogeneity factor (HIF) were used to quantitatively express the uniformity of distribution of effective plastic strain and Vickers microhardness, respectively. Compared with CSP and constrained groove pressing (CGP), the results showed that although the ultimate tensile strength (UTS) has significantly increased, the ductility values have remained almost constant. Moreover, in modified-CSP, the load-die stroke diagram increases almost evenly due to the removal of the stud interface area and progressive engagement. Therefore, modified-CSP copper sheets showed superior tensile properties such as good toughness.

Pearlite Interlamellar Spacing and Vickers Micro-Hardness in the Necking Region of Cold-Drawn Pearlitic Steel Wires

“…The relationship between plastic deformation and micro-hardness is well known and has been extensively analysed in different types of ductile materials from metals to new biomaterials [34][35][36]. In particular, studies have focused on analysing this relationship during the formation of necking since it is the predecessor and one of the most evident indicators of a fracture [37][38][39].…”