An Equivalent-Effect Phenomenon in Eddy Current Non-Destructive Testing of Thin Structures

Abstract

The inductance/impedance due to thin metallic structures in non-destructive testing (NDT) is difficult to evaluate. In particular, in Finite Element Method (FEM) eddy current simulation, an extremely fine mesh is required to accurately simulate skin effects especially at high frequencies, and this could cause an extremely large total mesh for the whole problem, i.e. including, for example, other surrounding structures and excitation sources like coils. Consequently, intensive computation requirements are needed. In this paper, an equivalent-effect phenomenon is found, which has revealed that alternative structures can produce the same effect on the sensor response, i.e. mutual impedance/inductance of coupled coils if a relationship (reciprocal relationship) between the electrical conductivity and the thickness of the structure is observed. By using this relationship, the mutual inductance/impedance can be calculated from the equivalent structures with much fewer mesh elements, which can significantly save the computation time. In eddy current NDT, coils inductance/impedance is normally used as a critical parameter for various industrial applications, such as flaw detection, coating and microstructure sensing. Theoretical derivation, measurements and simulations have been presented to verify the feasibility of the proposed phenomenon.INDEX TERMS Eddy current testing, electrical conductivity, non-destructive testing (NDT), skin effects, thickness measurement.

Evaluation of Coating Thickness Using Lift-Off Insensitivity of Eddy Current Sensor

“…In (1) and (2), and vary with the frequency of the exciting current and coating thickness . is the variable of integration, which is related to the wavenumber of the incident transverse electric (TE) planar electromagnetic wave [ 47 , 48 , 51 , 52 ]. is the material-dependent phase term for the mutual inductance.…”

Determination of Surface Crack Orientation Based on Thin-Skin Regime Using Triple-Coil Drive-Pickup Eddy-Current Sensor

“…is the fixed distance between the transmitter and receiver along − axis. α and α 1 are related to the wavenumber of the EM plane wave of Transverse electric (TE) mode [17] in the free space and test piece, respectively. α = √ 2 + 2 (5) (3) and h( , )e j( r + ) in (4) are the Fourier transform of the free-space magnetic scalar potential generated by the driving transmitter and pick-up receiver respectively, with h( , ) defined as the following expression.…”

A Novel Conductivity Classification Technique for Non-Magnetic Tilting Metals by Eddy Current Sensors

“…After picked up by the receiving coil, the secondary magnetic field induces electric current which would finally be measured by the impedance analyzer. The eddy current sensor is widely used in non-destructive test [10]- [12] due to non-contact, fast measuring, and economical devices. In [13]- [15], eddy current sensors are utilized to measure the conductivity.…”