An end of service life assessment of PMMA lenses from veteran concentrator photovoltaic systems

Abstract

The optical performance of poly(methyl methacrylate) lenses from veteran concentrator photovoltaic modules was examined after the end of their service life. Lenses from the Martin-Marietta and Intersol module designs were examined from the “Solar Village” site near Riyadh, Saudi Arabia, as well as the Phoenix Sky Harbor airport, followed by the Arizona Public Service Solar Test and Research (APS-STaR) center in Tempe, Arizona. The various lens specimens were deployed for 20, 27, and 22 years, respectively. Optical characterizations included lens efficiency (Solar Simulator instrument), material transmittance and haze (of coupons cut from veteran lenses, then measured again after their faceted back surface was polished, and then measured again after the incident front surface was polished), and direct transmittance (as a function of detector's acceptance angle, using the Very Low Angular Beam Spread (“VLABS”) instrument). Lens efficiency measurements compared the central region to the entire lens, also using hot and cold mirror measurements to diagnose differences in performance. A series of subsequent characterizations was performed because a decrease in performance of greater than 10% was observed for some of the veteran lenses. The optimal focal distance of the lenses was quantified using the Solar Simulator, and then correlated to lens curvature using a recently developed measurement technique. Surface roughness was examined using atomic force microscopy and scanning electron microscopy. Facet geometry (tip and valley radius) was quantified on cross-sectioned specimens. Molecular weight was compared between the incident and faceted surfaces of the lenses

Characterization and Long-Term Stability of Historical PMMA: Impact of Additives and Acrylic Sheet Industrial Production Processes

“…Most of the photodegradation studies on PMMA have been performed on pure polymer films prepared in laboratory, sometimes with controlled addition of other compounds/additives, and typically with radiation at λ < 300 nm to accelerate degradation. Fewer studies [ 19 , 28 , 29 , 30 ] have been conducted with commercial PMMA sheets and with radiations more similar to what an artwork may be exposed in real life.…”

Industrialization of hybrid Si/III–V and translucent planar micro‐tracking modules

“…[45][46][47] • The optical layer is made of optical silicone or solar-grade PMMA, materials that have also been qualified for photovoltaic applications, enduring extended exposure to UV radiation, humidity, and high ambient temperature. [48][49][50] The lens clusters are manufactured by injection molding, a low-cost industrial process with high throughput and good repeatability.…”

Thermal performance and design parameters investigation of a novel cavity receiver unit for parabolic trough concentrator

“…An alternative to the selective coating of the absorber pipe is application of a dielectric transparent (in visible) material inside the glass cover which reflects efficiently in the infrared. This type of coating is called a "hot mirror coating" (or "heat mirror coating") [8] [9] [10] [11]. The advantage of such an application is due to the glass cover being typically much cooler than the absorber pipe, and hence the absorber pipe's operating temperature can be raised until the glass cover temperature reaches the thermal breakdown limit of the hot mirror coating.…”