An Empirical Method for Predicting the Strength of Bim Materials Using Modifications of Lindquist’s and Leps’ Approaches

Sönmez, H.; Medley, Edmund W.; Kalender, Aycan; Dağdelenler, Gülseren; Özcan, Nazlı Tunar; Ercanoğlu, Murat

doi:10.1007/978-3-030-64518-2_90

Cited by 4 publications

(1 citation statement)

References 6 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…As highlighted in other researches (Tu et al 2021;Sonmez et al 2021), the strength envelope of S-RM samples, especially containing breakable blocks, is typically non-linear. As such, an improved non-linear Mohr-Coulomb strength criterion (N-MC criterion) was adopted.…”

Section: Shear Strength Parametersmentioning

confidence: 78%

Influence of Block form on the Shear Behaviour of Soft Soil–Rock Mixtures by 3D Block Modelling Approaches

et al. 2022

View full text Add to dashboard Cite

The influence of block forms on the shear behaviour of soil–rock mixtures with soft blocks (soft S–RMs) can be efficiently investigated by the discrete element method (DEM) on the basis of accurate 3D models accounting for the block breakage. This paper proposes a novel modelling approach, based on the spherical harmonics series, for the generation of 3D block geometries with different forms but same convexity and angularity. An already existing non-overlapping modelling approach was improved, characterized by a reduced computational cost, for the set-up of 3D block DEM models accounting for the block breakage. A number of soft S–RM DEM samples, subjected to numerical direct shear tests, were generated to analyze the influence of block forms and volumetric block proportion VBP on the mesoscopic and macroscopic behaviours. The results showed that the breakage degree is maximum for the spheroidal blocks, followed by the oblate, prolate and blade ones, due to the combined influence of the block frictional sliding and rotation. The shear strength of soft S–RMs is mainly controlled by the block interlocking and breakage, being maximum in the case of spheroidal block samples when the applied normal stress is low and in the case of prolate and blade ones for a high normal stress. It was found that a nonlinear Mohr–Coulomb criterion can provide a good description of the shear strength envelope of soft S–RMs. Soft S–RMs are characterized by a higher friction angle if composed by spheroidal and prolate blocks when the VBP is 40%, due to their elevated block interlocking, and in the case of prolate and blade blocks when the VBP is 60% at the higher normal stress, due to their lower block breakage degree.

show abstract

Section: Shear Strength Parametersmentioning

confidence: 78%