An Algorithm for a No-Contact Digital Three-Phase Voltage Detector

Kochurov, O. M.; Ковалев, Д. И.; Borisov, R. K.; Zhulikov, S. S.; Chernokoz, A. Ya.

doi:10.3103/s1068371218050048

Cited by 5 publications

(1 citation statement)

References 0 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The smart system must be resistant to wind load and remain operational under ice formation. It is proposed to use such digital current and voltage converters as digital smart sensors (DSS) [8] information, fixed on the phase conductors of the line, operating under phase wire potential [9,10]. Communication with the smart-system cabinet located on the line support will be realized by means of a dielectric optical cable (short-circuit bridges are excluded in case of cable breaks).…”

Section: Methodsmentioning

confidence: 99%

High-voltage smart electricity metering of 110 kV digital electric networks

Yurov

Voronov²,

Lukonin³

et al. 2021

E3S Web Conf.

View full text Add to dashboard Cite

Were considered the technical solutions sufficient for the development of smart systems for automatic information and measurement metering of electrical energy and monitoring of overhead power transmission lines of the 110-220 kV electrical grids, considering the integration of the data flow into Scada-systems of digital substation workplaces in all the accordance with the standard protocols of IEC 61850. The device allows you to control the quality of transmitted electricity, remotely monitor the condition of the line, thereby increasing the reliability of power supply and power flows in the power system, reducing the cost of operational teams for their inspection.

show abstract

Section: Methodsmentioning

confidence: 99%

High-voltage smart electricity metering of 110 kV digital electric networks

Yurov

Voronov²,

Lukonin³

et al. 2021

E3S Web Conf.

View full text Add to dashboard Cite

show abstract

Development of Monitoring Systems for High-Voltage Cast Resin Busbars1

et al. 2022

View full text Add to dashboard Cite

Hardware Design of Non-contact Voltage Detector Based on STM32 Microcontroller

Zhang

Shi

et al. 2020

IOP Conf. Ser.: Mater. Sci. Eng.

View full text Add to dashboard Cite

In view of the time-consuming and labor-intensive problems of traditional contact electroscopes, this paper designs a hardware system of non-contact voltage detector based on STM32 single-chip microcomputer. The hardware design mainly includes signal amplification and conditioning circuit and power module, Wireless transceiver module, display and alarm module, etc. In order to reduce the distortion of electric field caused by human during measurement, a wireless transceiver module device is adopted, which has a simple structure and can meet the engineering requirements of the non-contact power inspection of the transmission line.

show abstract

An Algorithm for a No-Contact Digital Three-Phase Voltage Detector

Cited by 5 publications

References 0 publications

High-voltage smart electricity metering of 110 kV digital electric networks

High-voltage smart electricity metering of 110 kV digital electric networks

Development of Monitoring Systems for High-Voltage Cast Resin Busbars1

Hardware Design of Non-contact Voltage Detector Based on STM32 Microcontroller

Contact Info

Product

Resources

About