Amide-Assisted Polymerization of 1,3-Butadiyne Containing Thiolate Ligands on Small Gold Nanoparticles

Abstract

Incorporation of directing amide groups has been shown to facilitate the topochemical polymerization of 1,3-butadiyne (diacetylene) groups in noncrystalline phases such as gels, amorphous solids, and liquid crystals. It remains challenging to polymerize 1,3-butadiyne-containing alkylthiolate ligands within their self-assembled monolayers on gold nanoparticles (AuNPs), which enhances their stability and adds new optical and electronic properties. Especially smaller AuNPs of sizes below 5 nm in diameter have been reported to display sluggish photopolymerization and are susceptible to photodegradation under UV irradiation. To probe the effectiveness of the amide-directed photopolymerization of 1,3-butadiyne ligands, small AuNPs in the 2–4 nm range were synthesized that contain alkylthiolate ligands with and without amide and 1,3-butadiyne groups. Their photopolymerization and photostability were studied by transmission electron microscopy (TEM), UV–vis spectroscopy, and Raman spectroscopy. AuNP with amide-free 1,3-butadiyne ligands templated the polymerization of the 1,3-butadiyne ligands but fused to large and insoluble particles during the polymerization process. AuNPs with ligands containing both 1,3-butadiyne and amide groups polymerized significantly faster, which slowed down photodegradation. A UV irradiation (254 nm and 176 W/m2) for 5–10 min was found to be optimal for the AuNPs with directing amide groups studied here, although their average core sizes grew from 3.8 to 4.0 nm in diameter and about 20% of the attached 1,3-butadiyne ligands remained unreacted after 10 minutes of irradiation. About 75% of the attached 1,3-butadiyne ligands were already polymerized during the first 5 min of UV irradiation. This decrease in reactivity is reasoned with a fast polymerization of ligands attached to facet sites and slower polymerization rates for ligands attached to edge and corner sites. Unexpectedly, photopolymerization occurred only in the presence of solvent, whereas no polydiacetylene was generated when dry powders of any of the diacetylene-containing gold nanoparticles were irradiated.