Ag thin film on an organic silane monolayer applied as anode of organic light emitting diode

Kawamura, Midori; Ishizuka, Yoshiki; Yoshida, Shota; Abe, Yoshio; Kim, K.H.

doi:10.1016/j.tsf.2012.10.108

Cited by 8 publications

(2 citation statements)

References 9 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…From the current density–voltage–luminance ( J – V – L ) characteristics shown in Figure 4 a,b, the threshold voltage of the iOLED was increased to 4.0 V compared to 2.8 V of the cOLED. This increase probably originated from the difference in the work function of ITO and Ag by inserting the MoO 3 layer, which was already confirmed in the study of green OLED with Ag electrodes, 26 whereas the interface roughness of the electrode can also be a factor affecting the work function because the film position (and the order of deposition) of the anode is different for the cOLED and iOLED. However, the current efficiency of the iOLED is comparable to that of the cOLED, as shown in Figure 4 c. This indicated that the recombination process itself was not affected by the introduction of the inverted structure.…”

Section: Resultsmentioning

confidence: 63%

CaF₂/ZnS Multilayered Films on Top-Emission Organic Light-Emitting Diode for Improving Color Purity and Moderation of Dark-Spot Formation

et al. 2022

View full text Add to dashboard Cite

Organic light-emitting diodes (OLEDs) have been widely used, particularly in display applications. OLEDs are easily degraded without stringent encapsulation owing to their susceptibility to water vapor and oxygen. Therefore, establishing an effective protection method for these devices is essential. In this study, we demonstrate the device protection performance and improvement in color purity by introducing CaF 2 /ZnS multilayered films on a top-emitting inverted-type OLED (iOLED), which was originally intended to act as a distributed Bragg reflector (DBR). To test the protection performance of each dielectric layer, conventional bottom-emitting OLEDs (cOLEDs) with and without single layers of CaF 2 and ZnS were investigated for comparison. All OLEDs were stored in an atmosphere without stringent encapsulation, such as a cover glass. The luminescence area of cOLEDs without the dielectric film decreased by more than 90% after 3 days of fabrication. In contrast, the dark-spot formation was moderated after the same period for the dielectric single-layer deposited cOLEDs. Notably, the iOLED with DBR completely preserved the emitting area even after 2 months of fabrication. This suggests that DBR acted as a protective film for the organic layer, whereas the inverted structure also contributed to reducing the degradation of air- and moisture-sensitive materials.

show abstract

Section: Resultsmentioning

confidence: 63%

CaF₂/ZnS Multilayered Films on Top-Emission Organic Light-Emitting Diode for Improving Color Purity and Moderation of Dark-Spot Formation

et al. 2022

View full text Add to dashboard Cite

show abstract

“…Article different area. [10][11][12][13][14][15] These films show high antibacterial and anticancer effects. They have excellent conductivity, chemical stability in aqueous solutions of any pH as long as oxidizing agents are not present.…”

Section: Introductionmentioning

confidence: 99%

Effect of post-annealing treatment on the wetting, optical and structural properties of Ag/Indium tin oxide thin films prepared by electron beam evaporation technique

Azizian‐Kalandaragh¹,

Nouhi²,

Amiri³

2015

mat express

View full text Add to dashboard Cite

In this approach, Ag thin films have been prepared using electron beam evaporation technique onto a thin film of tin-doped indium oxide coated ordinary glass substrate. The fabricated thin films were annealed in various temperatures: 100, 200, 300 and 400 C and the effect of annealing on their wetting, structural and morphological properties has been investigated. Scanning electron microscopy (SEM), UV-Visible spectroscopy (UV-Vis), diffuse reflectance spectroscopy (DRS), X-ray diffraction (XRD) and contact angle measurement have been applied for the characterization and study of thin film surfaces. The results of SEM exhibit the aggregation and formation of Ag nanoparticles on the surface of substrate changed through increasing of annealing temperature. The presence of mixed In 2 O 3 -Ag phases in the as-prepared and annealed samples was confirmed by XRD pattern. Optical behavior of thin films was followed by using diffuse reflectance spectroscopy. Wettability studies showed that the contact angle of prepared thin films was influenced by various parameters such as annealing temperature, surface morphology and composition of thin films.

show abstract

Optical characterization and emission enhancement property of Ag nanomesh structure fabricated by nanosphere lithography

Ugajin

Park

Kiba

et al. 2022

Surface and Coatings Technology

View full text Add to dashboard Cite

Ag thin film on an organic silane monolayer applied as anode of organic light emitting diode

Cited by 8 publications

References 9 publications

CaF₂/ZnS Multilayered Films on Top-Emission Organic Light-Emitting Diode for Improving Color Purity and Moderation of Dark-Spot Formation

CaF₂/ZnS Multilayered Films on Top-Emission Organic Light-Emitting Diode for Improving Color Purity and Moderation of Dark-Spot Formation

Effect of post-annealing treatment on the wetting, optical and structural properties of Ag/Indium tin oxide thin films prepared by electron beam evaporation technique

Optical characterization and emission enhancement property of Ag nanomesh structure fabricated by nanosphere lithography

Contact Info

Product

Resources

About

Ag thin film on an organic silane monolayer applied as anode of organic light emitting diode

Cited by 8 publications

References 9 publications

CaF2/ZnS Multilayered Films on Top-Emission Organic Light-Emitting Diode for Improving Color Purity and Moderation of Dark-Spot Formation

CaF2/ZnS Multilayered Films on Top-Emission Organic Light-Emitting Diode for Improving Color Purity and Moderation of Dark-Spot Formation

Effect of post-annealing treatment on the wetting, optical and structural properties of Ag/Indium tin oxide thin films prepared by electron beam evaporation technique

Optical characterization and emission enhancement property of Ag nanomesh structure fabricated by nanosphere lithography

Contact Info

Product

Resources

About

CaF₂/ZnS Multilayered Films on Top-Emission Organic Light-Emitting Diode for Improving Color Purity and Moderation of Dark-Spot Formation

CaF₂/ZnS Multilayered Films on Top-Emission Organic Light-Emitting Diode for Improving Color Purity and Moderation of Dark-Spot Formation