Adsorptive Removal of Selected Anionic and Cationic Dyes by Using Graphitic Carbon Material Prepared from Edible Sugar: A Study of Kinetics and Isotherms

Abstract

Graphitic carbon-like material (GCM) derived from edible sugar under a nitrogen environment was applied as an adsorbent for the removal of anionic and cationic dyes (methyl orange, MO) and methylene blue (MB) from wastewater. The physico-chemical characterization of GCM was analyzed by scanning electron microscopy (SEM), X-ray diffraction (XRD), Fourier transform infrared (FT-IR) spectroscopy, and X-ray photoelectron spectroscopy (XPS). The plate-like morphology with an average size of 50-100 nm was measured from the SEM images. The measured BET 'surface area and pore volume were 574 m 2 /g and 0.248 cm 3 /g, respectively with pore diameter (d), 1.8 47 (< 2 nm) indicates that the GCM classified as a microporous. The effects of dosage, pH, contact time and concentration on the adsorption of MB and MO onto GCM were studied to unveil the adsorption process. The experimental isotherm data concurred with the Langmuir isotherm model (R 2 = 0.990) for MB, while the MO isotherm data concurred with Freundlich model (R 2 = 0.995). The maximum adsorption capacity achieved from the Langmuir isotherm equation at 25 °C was 38.75 and 43.48 mg/g for MB and MO, respectively, which indicates that GCM is a suitable adsorbent for the adsorption of both anionic and cationic dyes. The kinetic study demonstrated that the adsorption of both dyes onto GCM was the pseudo-second-order diffusion kinetics. The thermodynamic parameters reveal the adsorption of both dyes was endothermic spontaneous through chemical interactions. The GCM was found to be a potential adsorbent for the removal of MB and MO from an aqueous solution.

Water Pollution and its Treatment using nanocomposites of graphene oxide (GO 50%) / Zn2+ for different dyes and heavy metals using sol-gel synthesized

“…The phases as ( 220), ( 311), (400), ( 422), (333), and (440) indicate the spinel cubic structure [31][32][33]. In addition, 111, 220, 311, 222, 400, 422, 511, 440 and 533 from the cubic system of zinc ferrite [34]. Intensity (a.u.…”

Recent research progress on modified activated carbon from biomass for the treatment of wastewater: A critical review

“…However, because of its higher elimination effectiveness and lower operating temperature by utilizing affordable adsorbents, adsorption is the most efficient process for concurrently removing heavy metal ions and dyes. Heavy metal ion adsorption over nonmagnetic adsorbents like AC and alumina has received a lot of attention in recent years (Ahmadpour et al., 2010; Choi, et al., 2018; Lingamdinne, Choi, et al., 2018; Lingamdinne, Singh, et al., 2018; Rahmani et al., 2010; Zabihi et al., 2009; Zabihi et al., 2010). Recent studies have concentrated on supporting magnetic nanoparticles onto AC to increase the adsorption capability.…”

Selective Removal of Sodium Ions from Aqueous Media Using Effective Adsorbents: Optimization by RSM and Genetic Algorithm

“…The Freundlich equilibrium isotherm is based on the multilayer and heterogeneous adsorption on the adsorbent. The linear form of this equation is expressed below: 37 (4) where, k F (mg/g(L/mg) 1/n ) and n are the Freundlich constants: 38 The Langmuir isotherm model assumes monolayer sorption on a surface containing a limited number of uniform energy adsorption sites. 36 This model also states that adsorption only occurs on homogeneous sites, without any action between the adsorbate and adsorbent molecules.…”