The study aims to develop an eco-friendly solution for addressing contaminants in hospital wastewater. To achieve this, banana peel, a cost-effective and easily available agricultural waste, was chemically modified using sulfuric acid and sodium hydroxide. The hospital wastewater was analyzed using an Atomic Absorption Spectrometer to identify the presence of heavy metals. The physicochemical properties were measured and compared against the standards set by the World Health Organization (WHO). Scanning electron microscopy and Fourier-transform infrared spectroscopy were used to characterize the chemically modified banana peel. Batch adsorption was conducted with the wastewater using the prepared adsorbent. The effect of contact time, mixing rate, temperature, and adsorbent dosage was examined to know the removal efficiency of the adsorbent. The experimental design incorporates Taguchi OA design to optimize the process. The total heavy metals discovered in the wastewater were As, Cd, Fe, Cu, Ni, Cr, Pb, Mn and Zn. The percentage of Cd, Fe, Cu, Ni, Cr and Pb removed were 79.5%, 87.9%, 56.9%, 89.0%, 88.5% and 93.5%, respectively, at temperature, adsorbent dosage, mixing rate and contact time of 30 °C, 3 g, 700 rpm and 60 min, respectively. The physicochemical properties remain within the acceptable WHO range except the turbidity. At optimum point, the percentage removal of Cd, Fe, Cu, Ni, Cr, Pb and Zn were 64.3%, 80.5%, 51.4%, 82.3%, 72.4%, 86.6% and 72.1%, respectively; while, the conductivity, pH, TDS, and turbidity value were, respectively, 20.57 mS/cm, 6.8, 10.16 mg/l, and 86.31 NTU. Characterization revealed the existence of active functional groups on the adsorbent surface enhancing the hospital wastewater treatment and change in its morphological structure after the treatment was noticed. In conclusion, the modified banana peel was effective for the treatment of hospital wastewater.
