Accurate measurement, using natural sunlight, of silicon solar cells

Abstract

The light source is very important when measuring solar cells. Commonly used light sources—good‐quality solar simulators—are expensive and have far from ideal characteristics. Computer modelling described in this work strongly suggests that testing of silicon solar cells under natural sunlight is simpler, cheaper, and more accurate than all but the most careful simulator measurements. Direct‐beam solar spectra were generated with the model SMARTS2 for a range of atmospheric conditions, and a broad range of silicon cells (efficiencies 6–25%) were then simulated under these spectra. These simulations showed that measurement uncertainty of less than 5% should be achievable. Climate data for locations within 45° of the equator show that the required atmospheric conditions should occur commonly in summer. Finally, it is shown that the important atmospheric conditions can be measured without expensive equipment. Copyright © 2004 John Wiley & Sons, Ltd.

Methods to determine the dc parameters of solar cells: A critical review

“…In the former case the measurements can be performed under dark or illuminated conditions, in the latter case solar simulators being used [6][7][8][9][10][11][12][13][14][15][16][17][18][19][20][21][22][23][24][25].…”

Diurnal Characteristics of Angstrom Turbidity Parameters Over Manila, Philippines

“…It is the extinction coefficient corresponding to 1-μm wavelength. Typically, the values of β range from 0.0 to 0.5 wherein values like 0.0, 0.1, 0.2 and 0.4 correspond to a clean, clear, turbid and a very turbid atmosphere, respectively [11][12][13]. This means that, the larger the value of β, the more turbid the atmosphere is.…”

Uncertainties on the outdoor characterization of PV modules and the calibration of reference modules

“…As the temperature uncertainty is the major contribution to the overall uncertainty for the latter, the implementation of a temperature control system for the box (to stabilize the module at the desired temperature of 25 o C) in which the module is mounted would be beneficial" (Müllejans et al, 2009). The superiority of natural sunlight for PV measurements has also been highlighted by other authors (Keogh and Blakers, 2004). In fact, several primary calibration techniques use it (Müllejans et al, 2005b).…”