About Ways of the Task of Orientation of the Working Body of the Robot Manipulator

Хомченко, В. Г.

doi:10.25206/2310-9793-2018-6-2-76-81

Cited by 1 publication

(1 citation statement)

References 0 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…If the robot needs to interact with an object whose position and orientation are set at some space point M, then, when planning the movements, it is necessary to check that the point M is reachable, and that there are alternatives to the acceptable configurations of the manipulator at this point, and that there is a possibility to enable the orientation of the grip to capture and hold the object during programmed movements. Study [7] proposes an algorithm that sets the required orientation of the manipulator grip within the selected space of the Cartesian coordinates. The authors considered 54 orientation-setting techniques based on the 3×3 turn matrix, and six based on Euler's angles.…”

Section: Literature Review and Problem Statementmentioning

confidence: 99%

Devising a method to analyze the current state of the manipulator workspace

Ashhepkova

2021

EEJET

View full text Add to dashboard Cite

This paper has proposed a program analysis method over the current state of the workspace of an anthropomorphic manipulator using the Mathcad software application package (USA). The analysis of the manipulator workspace helped solve the following sub-tasks: to calculate the limits of the grip reach, to determine the presence of "dead zones" within the manipulator workspace, to build the boundaries of the manipulator workspace. A kinematic scheme of the manipulator typically provides for at least five degrees of mobility, which is why in the three-dimensional Cartesian coordinate system the work zone boundaries represent the surfaces of a complex geometric shape. The author-devised method makes it possible to construct the projections of the boundaries of the manipulator's work zone onto the coordinate planes in the frame of reference associated with the base of the robot. Using Mathcad's built-in features makes it possible to effectively solve the above sub-tasks without wasting time developing specialized software. The Mathcad software application package provides for the possibility of a symbolic solution to the first problem of the kinematics of an industrial robot, that is, the program generates analytical dependences of the coordinates for special point P (pole) of the grip on the trigonometrical functions of the generalized coordinates. The resulting analytical dependences are used for kinematic and dynamic analysis of the manipulator. Special features in constructing mathematical models when using the Mathcad software application package have been revealed. Simulating the manipulator movement taking into consideration constraints for kinematic pairs, the drives' power, as well as friction factors, makes it possible to optimize the parameters of the manipulator kinematic scheme. An example of the analysis of the working space of an anthropomorphic manipulator with five degrees of mobility has been considered. The reported results could be used during the design, implementation, modernization, and operation of manipulators.

show abstract

Section: Literature Review and Problem Statementmentioning

confidence: 99%

Devising a method to analyze the current state of the manipulator workspace

Ashhepkova

2021

EEJET

View full text Add to dashboard Cite

show abstract

About Ways of the Task of Orientation of the Working Body of the Robot Manipulator

Cited by 1 publication

References 0 publications

Devising a method to analyze the current state of the manipulator workspace

Devising a method to analyze the current state of the manipulator workspace

Contact Info

Product

Resources

About