Ablation resistance of resin matrix composites modified with different MAX-phase materials

Ma, Chen; Chou, Zhijian; Mao, Shenhua; Xu, Weiye; Ma, Z.Y.; Gao, Lihong; Chen, Guohua

doi:10.1016/j.compscitech.2022.109687

Cited by 14 publications

(2 citation statements)

References 31 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…2D FRRMC has the advantages of high specific strength, low mass, good thermal stability, high chemical stability, designability, and excellent fatigue resistance. It has been widely used in marine, offshore, aerospace, and civil infrastructures for 60 or 70 years 15–21 . Nowadays, fiber‐reinforced composites are used, as shown in Figure 2.…”

Section: Introductionmentioning

confidence: 99%

A review of the effect of hydrothermal aging on the mechanical properties of 2D fiber‐reinforced resin matrix composites

Li,

Feng,

Zhang

et al. 2024

Polymers for Advanced Techs

View full text Add to dashboard Cite

Abstract2D fiber reinforced resin matrix composites (2D FRRMC) are widely applied for aerospace, generator blades, and other high‐end equipment manufacturing fields due to their excellent mechanical properties. However, 2D FRRMC will face a variety of complex environments in the service process, and the long‐term complex environment will significantly impact the physical and mechanical properties of 2D FRRMC. It is necessary to understand and analyze the changes of materials during service. A comprehensive review of the research on the effect of hydrothermal aging on the mechanical properties and re‐ drying of 2D FRRMC in recent years was presented in this article, which contains interlaminar shear properties, compression properties, tensile properties, and aging mechanism, etc. Finally, the current challenges and prospects of 2D FRRMC were discussed. These discussions and proposed strategies will enlighten thoughts and offer ways to apply 2D FRRMC in complex environments better, study 2D FRRMC in complex environments, and study the effects of hydrothermal aging on materials in the future.

show abstract

Section: Introductionmentioning

confidence: 99%

A review of the effect of hydrothermal aging on the mechanical properties of 2D fiber‐reinforced resin matrix composites

Li,

Feng,

Zhang

et al. 2024

Polymers for Advanced Techs

View full text Add to dashboard Cite

show abstract

“…In addition, fiber-reinforced (especially carbon fiber) phenolic resins face the challenge of rapid oxidative failure at high temperatures. [11,12] Therefore, coating over fiber-reinforced phenolic resins has become an attractive solution to this problem. Y. W. Pan et al [13] prepared TiO 2 -coated carbon fiber felt/ phenolic resin aerogel composites.…”

Section: Introductionmentioning

confidence: 99%

Yttrium Silicate‐Coated Carbon Fiber Reinforced Phenolic Aerogel‐like Composites with Low Density and Low Ablation

Sun,

Wang,

Huang

et al. 2024

ChemistrySelect

View full text Add to dashboard Cite

The evolution of hypersonic vehicles has raised higher requirements for thermal protection materials, which have become the focus of research on how to meet the lightweight and less ablative. Herein, a yttrium silicate‐coated carbon fiber felts (YS‐CFs) reinforced phenolic aerogel‐like (PR) composites were prepared. The YS‐CFs/PR with the addition of 12 % hexamethylenetetramine exhibited low density (0.540 g/cm3), low thermal conductivity (0.145 W/(m⋅K)), and good thermal stability. Specifically, under an oxyacetylene flame examination with 2.44 MW/m2 heated for 120 s, its mass ablation rates (9.833 mg/s) and line ablation rates (5 μm/s) were decreased by 40.8 % and 32.6 %, respectively, compared to others. The results show that the composites with these combined properties can meet the requirements for thermal protection materials in the field of hypersonic vehicles.

show abstract

Design and preparation of resin matrix composite coating with good ablation resistance performance under high-energy laser irradiation

Xue

Peng

Huang

et al. 2023

Ceramics International

View full text Add to dashboard Cite

Ablation resistance of resin matrix composites modified with different MAX-phase materials

Cited by 14 publications

References 31 publications

A review of the effect of hydrothermal aging on the mechanical properties of 2D fiber‐reinforced resin matrix composites

A review of the effect of hydrothermal aging on the mechanical properties of 2D fiber‐reinforced resin matrix composites

Yttrium Silicate‐Coated Carbon Fiber Reinforced Phenolic Aerogel‐like Composites with Low Density and Low Ablation

Design and preparation of resin matrix composite coating with good ablation resistance performance under high-energy laser irradiation

Contact Info

Product

Resources

About