A vehicle classification based on inductive loop detectors

Gajda, Janusz; Sroka, Ryszard; Stencel, Marek; Wajda, A.; Żegleń, Tadeusz

doi:10.1109/imtc.2001.928860

Cited by 113 publications

(54 citation statements)

References 1 publication

Supporting

Mentioning

Contrasting

Unclassified

Order By: Relevance

“…1, are used. The solution applied by authors in former works [2,4,9] employs an AC bridge (Fig. 1a).…”

Section: Magnetic Signature Measurement Systemsmentioning

confidence: 99%

See 1 more Smart Citation

A Highly Selective Vehicle Classification Utilizing Dual-Loop Inductive Detector

Gajda¹,

Stencel²

2014

Metrology and Measurement Systems

View full text Add to dashboard Cite

In general, currently employed vehicle classification algorithms based on the magnetic signature can distinguish among only a few vehicle classes. The work presents a new approach to this problem. A set of characteristic parameters measurable from the magnetic signature and limits of their uncertainty intervals are determined independently for each predefined class. The source of information on the vehicle parameters is its magnetic signature measured in a system that enables independent measurement of two signals, i.e. changes in the active and reactive component of the inductive loop impedance caused by a passing vehicle. These innovations result in high selective classification system, which utilizes over a dozen vehicle classes. The evaluation of the proposed approach was carried out for good vehicles consisting of 2-axle tractor and a 3-axle semi-trailer.

show abstract

“…1, are used. The solution applied by authors in former works [2,4,9] employs an AC bridge (Fig. 1a).…”

Section: Magnetic Signature Measurement Systemsmentioning

confidence: 99%

“…Publication [4] discusses the influence of the inductive-loop detector length (in the vehicle motion direction) on the shape of magnetic signatures obtained for vehicles belonging to diverse classes. According to the presented results a signature obtained from a very short loop (10cm) allows axle counting and axle spacing measurement.…”

Section: Introductionmentioning

confidence: 99%

A Highly Selective Vehicle Classification Utilizing Dual-Loop Inductive Detector

Gajda¹,

Stencel²

2014

Metrology and Measurement Systems

View full text Add to dashboard Cite

show abstract

“…가상 루프 검지기를 이용한 방식은 한 차선에 1～2개의 가상 검지선을 설정하고 이를 이용하여 속도를 측정하는 방 식이다 [8][9][10][11][12]. 이 때 J. Gajda [10]과 B.L.…”

Section: 기존의 Atis를 위한 교통 정보 수집에 관한 연구unclassified

“…이 때 J. Gajda [10]과 B.L. Tseng [11]은 속도 뿐만 아니라 차량이 1개의 검지선을 통과하는 시간을 이용 하여 차량의 길이를 추정함으로써 통과하는 차량의 차종 분 류를 시도함으로써 차선뿐만 아니라 차종별 교통 정보를 수 집하려 하였다.…”

Section: 기존의 Atis를 위한 교통 정보 수집에 관한 연구unclassified

Real-Time Traffic Information Collection Using Multiple Virtual Detection Lines

Kim¹,

Kim²,

Lee³

et al. 2008

The KIPS Transactions:PartB

View full text Add to dashboard Cite

ATIS(Advanced Traveler Information System) is the system to offer a real-time traffic information or traffic situation for the benefit of the client. One of traffic information collection methods for ATIS research is the method of image analysis. The method is divided into two : one is the method to set two loop detectors at the area and the other is the method detecting the vehicle through an image analysis. In this paper, we propose a real-time traffic information collection system to mix two methods. The system installs multiple virtual detection lines and traces the location of the vehicle. Use of multiple virtual detection lines supplements the defect of the method of loop detectors. And we drew a representative pixels in the detecting area and used it for image analysis. This is to solve the problem of time delay which increases as the image size increases. We gathered traffic images and experimented using the system and got 92.32% of detection accuracy.

show abstract

“…The most widely-used practice in traffic monitoring is to embed Inductive Loop Detectors (ILDs) in well-traveled highways every mile (or half-mile) [7,17]. ILDs measure traffic flow by registering a signal each time a vehicle passes over.…”

Section: Introductionmentioning

confidence: 99%