A Study on Position Control of a Continuum Arm Using MAML (Model-Agnostic Meta-Learning) for Adapting Different Loading Conditions

Abstract

Predicting tip positions of a spring based continuum manipulator is highly challenging due to its nonlinear deformations. External loading on the tip further deteriorates the accuracy. Model-less control has shown great success in the tip positioning. However, the model less control strategies require a large data set and considerable amount of time for the training. Performance of these controllers also deteriorates with external loads. To address these problems, this paper presents a MAML(Model-Agnostic Meta-Learning) based closed loop controller for the continuum manipulators. This controller requires relatively small amount of data to achieve the state-of-art positioning accuracy. It can also adapt to the changes due to the external loads with less than 2.5 percent of the original data. Two algorithms for the offline adaptation of the known and unknown external loading are proposed. This technique is also helpful for automatic stiffness tuning of the spring based continuum manipulators. The experimental validations have been done on the simulation environment and on the real prototype. The continuum arm used for the experimentation is a tendon based non constant curvature spring-based manipulator. The average relative positioning error for the zero loading case was found to be 3.83% on the spring based prototype . The controller was successful in bringing down the relative tip positioning error of the manipulator from 5.42% to 2.7% in the simulation environment. It also showed success in bringing down the relative tip positioning error from 7.8% to 3.96% on the real prototype. Average relative tip positioning errors below 4.27% and 4.89% have been achieved in the trajectory following tasks for the known and unknown external loading cases respectively.

Continuum Robots and Magnetic Soft Robots: From Models to Interdisciplinary Challenges for Medical Applications

“…Soft robots have notably adopted these advanced technologies, achieving significant breakthroughs [ 56 , 118 , 119 ]. This trend has also captivated researchers in continuum robots, a field grappling with nonlinear modeling challenges, spurring extensive research into data-driven modeling methodologies for continuum robots [ 48 , 120 , 121 ]. Data-driven modeling relies heavily on collecting and preprocessing high-quality data and selecting features and models carefully.…”

Static Shape Control of Soft Continuum Robots Using Deep Visual Inverse Kinematic Models

“…Thuruthel et al [52] proposed a formulation which can achieve direct inversion of FK through linearisation at the current state. Sahoo et al [53] expanded on this work by employing a meta-learning approach to reduce the training sample required for adapting the network to unknown tip-loading conditions. Distal learning is another method for inverting the kinematics of a redundant robot and has been used for soft robots by Melingui et al [54].…”