A Study on Parameter Optimization for Circumferential Gas Tungsten Arc (GTA) Welding of Small Pipes considering Backing Gas Pressure: Part 1: Analysis of Weld Pool Surface Profile

Abstract

It is well known that the weld bead becomes wider and the weld pool hangs down as the circumferential welding of small-diameter pipes progresses, if constant welding conditions are maintained over the entire joint length and/or no appropriate backing gas is supplied into the pipe. In order to obtain a weld bead which is uniform in width and does not hang down over the whole circumference of the pipe, the welding parameters such as welding current, welding velocity and backing gas pressure should be optimized as the welding progresses. In order to optimize the welding parameters, a mathematical model for determining the temperature distribution in the pipe workpiece and the surface profile of the resultant weld pool is indispensable. An efficient finite difference model was adopted for calculating the three-dimensional transient temperature distribution in circumferential gas tungsten arc (GTA) welding of pipes. Its solution was obtained by employing the alternating direction implicit (ADI) finite difference method, in which a periodic boundary condition and a periodic cubic spline function were used. For calculating the weld pool surface profiles in full penetration circumferential welding of pipes, a governing equation was derived in the cylindrical coordinate and solved using a simple finite difference model with the ADI scheme. In Part 2 of this paper, an efficient parameter optimization method is used to evaluate the optimal welding current for a required bead width when the welding velocity is given.