A study on influence of vegetable oils in milling operation and it’s role as lubricant

Shreeshail, M.L.; Desai, Amol C.; Siddhalingeshwar, I. G.; Kodancha, Krishnaraja G.

doi:10.1016/j.matpr.2021.02.392

Cited by 6 publications

(2 citation statements)

References 12 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Mineral oil was used as the base fluid to reduce the surface roughness and material loss. It has better lubrication properties than water or dry machining [21]. The white mineral oil was mixed with the nanoparticle at a ratio of 0.4g for 1 liter of mineral oil.…”

Section: Preparation Of Nano Cutting Fluidmentioning

confidence: 99%

Experimental Study and Finite Element Analysis of Temperature Reduction and Distribution During Machining of Al-Si-Mg Composite Using Deform 3D

Okokpujie

Akujieze

Sinebe

et al. 2022

ARFMTS

View full text Add to dashboard Cite

Composite materials are promising materials in the manufacturing industry due to the quality of their materials. However, in transforming these materials, the machining process experiences a high-heat generation rate, which has led to the study of temperature distribution, and reduction analysis at the cutting region. High-temperature generation during machining operation leads to thermal deformation on the developed component or parts, affecting the operation life span of the component. Thus, this study investigated the effect of mineral oil-based-Multi-walled carbon nanofluid (MWCNTs) compared to pure mineral oil in the turning of aluminum-silicon magnesium metal composite (AlSiMg) on temperature reduction and distribution. The nanofluid was prepared with 0.4g of MWCNT to 1 liter of mineral oil. The study employed the energy dispersive spectrometer to obtain the chemical composition of the developed nanofluid. Furthermore, Finite element software DEFORM 3D v11.0 uses a lagrangian incremental approach to simulate chip formation and temperature distribution on the workpiece. Also, to study the effects of the machining parameters on the temperature distribution. The experiment results showed a significant reduction of 11.9% in temperature when machining with nanofluid compared to pure mineral oil. The simulation results showed that the temperature increases as the cutting speed and feed rate increase. The minimum temperature via the DEFORM 3D Finite Element Model simulation was achieved at spindle speed 870 rpm, feed rate 2 mm/rev, and depth-of-cut 1 mm. In conclusion, the study recommends that the manufacturing industry employ the optimized machining parameters during the turning of AlSiMg metal matrix composite for a sustainable machining process.

show abstract

Section: Preparation Of Nano Cutting Fluidmentioning

confidence: 99%

Experimental Study and Finite Element Analysis of Temperature Reduction and Distribution During Machining of Al-Si-Mg Composite Using Deform 3D

Okokpujie

Akujieze

Sinebe

et al. 2022

ARFMTS

View full text Add to dashboard Cite

show abstract

“…Jatropha oil outperformed other oils in terms of lubrication requirements and shape errors. Shreeshail et al [ 28 ] investigated the effects of groundnut oil and soybean oil during the milling of mild steel and aluminum alloy. In lubricating circumstances, more cutting force was required to mill a metal to achieve a better surface quality than it was in dry environments.…”

Section: Introductionmentioning

confidence: 99%