A Slip-Line Field Model for the Determination of Chip Curl Radius

Liu, X. D.; Lee, L. C.; Lam, K.Y.

doi:10.1115/1.2803312

Cited by 7 publications

(1 citation statement)

References 15 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Ramalingam (1991 and1993) reviewed previous slipline models and used a new slip-line solution to calculate chip geometry from a groove tool. Liu et al (1995) worked on their slip-line field model for prediction of chip curl radius.…”

Section: Chip Up-curlmentioning

confidence: 99%

Chip-controlled 3-D complex cutting tool insert design and virtual manufacturing simulation

Luo

View full text Add to dashboard Cite

This manuscript has been reproduced from the microfilm master. UMI films the text directly from the original or copy submitted. Thus, some thesis and dissertation copies are in typewriter face, while others may be from any type of computer printer.The quality of this reproduction is dependent upon the quality of the copy submitted. Broken or indistinct print, colored or poor quality illustrations and photographs, print bleedthrough, substandard margins, and improper alignment can adversely affect reproduction.In the unlikely event that the author did not send UMI a complete manuscript and there are missing pages, these will be noted. Also, if unauthorized copyright material had to be removed, a note will indicate the deletion.Oversize materials (e.g., maps, drawings, charts) are reproduced by sectioning the original, beginning at the upper left-hand comer and continuing from left to right in equal sections with small overiaps. Each original is also photographed in one exposure and is included in reduced form at the back of the book.

show abstract

Section: Chip Up-curlmentioning

confidence: 99%