A Resonator Enhanced UHF RFID Antenna Cable for Inventory and Warehouse Applications

Abstract

Structures to improve the RF properties of leaky coaxial cables (LCX) are proposed. These resonator structures are optimized for UHF RFID frequency of 866 MHz; however, they are applicable also to other frequencies of interest by redimensioning with corresponding data. Simulations of leaky coaxial cables with resonators (denoted "RCX") show to improve the antenna gain, which is verified also by measurements. Compared to traditional LCX, RCX have increased radiating power capability while the shape of the propagated wave is also controlled. Cables are simulated with lengths 2.1 m and 6.4 m where the number of radiating slots and resonators is varied. RCXs exhibit a much higher radiation capability than LCXs. The radiation efficiency for RCXs is between 40 %...60 % whereas an LCX has only 0.2 % efficiency. Simulations are complemented with measurements of the 2.1 m cables. A 30x improvement of the read range of passive RFID tags are reported in tests, from 0.05 m to 1.5 m along the resonator cable. The cable length can be extended so that the signal is carried to the radiating point of the cable using conventional, i.e., non-radiating coaxial cable.

A Prospective Look on Optimization Methods For RFID Systems: Requirements, Challenges and Implementation Aspects

“…2 shows, in the active RFID systems the two significant components are antenna and amplifiers that is connected to the smart card chip. For proper working of RFID system, designing and optimizing high performance antennas [15], [16], [17] and amplifiers [18], [19], [20], [21], [22], [23], [24], [25] are required where advanced optimization methods must be employed for configuring and sizing these designs [26], [27], [28], [29], [30], [31], [32].…”