A Quality Study of a Self-Piercing Riveted Joint between Vibration-Damping Aluminum Alloy and Dissimilar Materials

Abstract

This study investigates the quality of self-piercing riveted joints between vibration-damping aluminum (Al) and other dissimilar materials, namely aluminum alloy (AL5052-H32), steel alloy (GA590DP), and carbon-reinforced plastic (CFRP). The effects of die types (flat, cone, and nipple) on the geometrical characteristics and mechanical performance of the joints are studied using a cross-section examination and tensile shear load testing. The failure modes of each joint are also presented, showing the nature of the forces leading to the joint failures. The results indicate that, for all configurations, adequate joining between vibration-damping Al with AL5052-H32 is expected with a maximum shear load up to 3.28 kN. A shear load up to 3.6 kN was measured for the joints with GA590DP panels with acceptable top and bottom seal characteristics. A vibration-damping Al panel can only be positioned at the bottom when riveting with CFRP due to the brittle nature of CFRP. A tensile shear load up to 2.26 kN was found, which is the lowest amongst the materials tested in this study.