A Novel Online Control Method for Hybrid Active Power Filter with Injection Circuit

Chau, MinhThuyen; Luo, An; Chau, VanBao; Nguyen, T.

doi:10.1109/appeec.2012.6307380

Cited by 1 publication

(1 citation statement)

References 7 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…According to IEEE standards [32], the single harmonic content and total harmonic content for 1 kV -69 kV common connection points cannot exceed 3% and 5%, respectively. Because 50 Hz, 150 Hz, 250 Hz, 350 Hz, and 1000 Hz have been used in relevant research results [33][34][35], this paper analyzes the harmonic distortion rate of these frequencies in the 10kV power grid. The result is shown in Figure 4.…”

Section: B Frequency Selection Principlementioning

confidence: 99%

Active High-Impedance Fault Detection Method for Resonant Grounding Distribution Networks

Yao,

Liu,

Chen

et al. 2024

IEEE Access

View full text Add to dashboard Cite

Aimed at the high-impedance fault detection problem, this paper proposes a fault-feature enhancement method for actively detecting high-impedance faults. The essential characteristic of this method is that the fault features are actively enhanced without affecting the normal terminal voltage. The method consists of two stages, i.e., the feature-enhancement stage and the fault-detection stage. The terminal voltage difference between the fault and normal state is analyzed in the first stage. Then, the feasibility of enhancing terminal voltage difference by the auxiliary signal is proved, and the selection criteria of the auxiliary signal is determined based on IEEE standards. In the second stage, the local-scale energy entropy ratios are applied to reconstruct the measurements. Then, high-impedance faults are detected by discriminating reconstructed data statistical characteristics differences before and during the fault. The simulation results show that the proposed method can accurately identify high-impedance faults with 75 kΩ transition impedance in an environment with a signal-to-noise ratio of 15 dB and reliably detect the faults with 75 kΩ transition impedance on buses and feeders at different positions. The method is robust to noise, transition impedance, and switching events.

show abstract

Section: B Frequency Selection Principlementioning

confidence: 99%