A Novel Multi-Functional DSTATCOM with Distribution Generation using FRC Controller

Prakash, Ch. S. V.; Rao, G. Kesava; Sekhar, O. Chandra; Satyaramesh, P. V.

doi:10.11591/ijece.v8i3.pp1373-1382

Cited by 3 publications

(3 citation statements)

References 16 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Thus, any disturbance needs to be filtered. Otherwise, the conventional types of wind turbines can directly transfer these fluctuations to the electricity grid [22].…”

Section: Problem Formulation 21 Impact Of Wind Turbines High Penetrmentioning

confidence: 99%

The transient stability analysis of wind turbines interconected to grid under fault

Gourma¹,

Berdai²,

Reddak³

2020

IJECE

View full text Add to dashboard Cite

Wind farm has been growing in recent years due to its very competitive electricity production cost. Wind generators have gone from a few kilowatts to megawatts. However, the participation of the wind turbine in the stability of the electricity grid is a critical point to check, knowing that the electricity grid is meshed, any change in active and reactive flux at the network level affects its stability. With a rate of 50% wind turbine penetration into the electricity grid, the stability of the rotor angle is a dynamic phenomenon which is only visible by the variation of the active energy. The purpose of this journal is to verify the impact of wind turbine integration on an electrical grid, by exploiting the relationship between the reactive energy produced by the Doubly Fed Induction Generator equipping most wind energy systems, and the stability of the rotor angle of the synchronous generators equipping the conventional power plants in the electrical system.

show abstract

“…Thus, any disturbance needs to be filtered. Otherwise, the conventional types of wind turbines can directly transfer these fluctuations to the electricity grid [22].…”

Section: Problem Formulation 21 Impact Of Wind Turbines High Penetrmentioning

confidence: 99%

The transient stability analysis of wind turbines interconected to grid under fault

Gourma¹,

Berdai²,

Reddak³

2020

IJECE

View full text Add to dashboard Cite

show abstract

“…When a failure is occurred in the ESS, the other units will not be affected, also the use of ESS reinforce the DFIG dc link [23]. The D-STATCOM in its basic structure [26] can only exchange reactive power with the network, but if the voltage source inverter is interconnected with an ESS the D-STATCOM can exchange the active power.…”

Section: Energy Storage For Dfig Wind Turbinementioning

confidence: 99%

Energy storage of DFIG based wind farm using D-STATCOM

Rabyi¹,

Mahmoudi²

2019

IJECE

View full text Add to dashboard Cite

<p>To accommodate the regularity of wind energy; a storage device is required for the wind turbine. This paper proposesa constant power control for wind farm based Doubly Fed Induction Generator, the suggested storage device is supercapacitor which is connected to every wind turbine of the wind farm, it provides output power stability and compensates the deviations between the available wind energy input and the desired active power output. A Distribution – Static Synchronous Compensator (D-STATCOM) is connected at the point of connection of the wind farm, it controls the active and reactive power according to the demand from orpower generation to the electrical grid. The coordinated approach between the supercapacitors and the D-STATCOM mitigates the voltage magnitude fluctuations of the wind farm and provides support to the active power. Simulation studies are carried out inMATLAB/Simulink.

show abstract

“…The maximum thermal capacity of transmission circuits in power systems can be achieved by using flexible AC transmission systems technique that is based on controlled electronic devices [1]. Often, FACTS basically means the regulation of the three basic parameters that directly affect the transmitted AC power capacity that is voltage, impedance and phase angle [2,3].…”

Section: Introductionmentioning

confidence: 99%

Hybrid control strategies of SVC for reactive power compensation

Aziz

Abdullah

2020

IJEECS

View full text Add to dashboard Cite

<span>This article shows a prospective utilizations of flexible AC transmission system (FACTS) controls, like the static VAR compensator (SVC). One of the major motives for setting up an SVC is to recover dynamic voltage controller and thus increase system load aptitude. Static VAR compensator system proposed in this work consists of thyristor switched capacitor and thyristor controlled reactor sets, this style of SVC modelled using MATLAB simulink toolbox. A hybrid genetic algorithm with PI and fuzzy logic controls that used to control and expand the grid performance of the power system. The model results reveal that the Static Var Compensation contribute a decent result in upholding bus voltage after the power network is in an active and steady moment, besides it has a capability of the constancy control. It can totally work as a significant plan of reactive power recompense in power networks. </span>

show abstract

A Novel Multi-Functional DSTATCOM with Distribution Generation using FRC Controller

Cited by 3 publications

References 16 publications

The transient stability analysis of wind turbines interconected to grid under fault

The transient stability analysis of wind turbines interconected to grid under fault

Energy storage of DFIG based wind farm using D-STATCOM

Hybrid control strategies of SVC for reactive power compensation

Contact Info

Product

Resources

About