A Novel Low Power Hexagonal Gas Sensor Cell for Multi-Channel Gas Detection

Xie, Dongcheng; Liu, Ruichen; Adedokun, George; Xu, Lei; Feng, Wei

doi:10.1109/mems51782.2021.9375230

Cited by 9 publications

(7 citation statements)

References 8 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The maximum power consumption of this circuit is only 4.6 mW. The authors of [28] report a hexagonal gas sensor cell for multi-channel gas detection. Six sensors are integrated with a hexagonal micro-hotplate to make up the sensor cell.…”

Section: Gas Sensorsmentioning

confidence: 99%

“…Feeding ability of the system and both architectures at 22 m from relay antenna compared to minimum required power supply of the gas sensors. The DC powers A1, B1, C1, D1 and E1 correspond to the power supply of sensors given in the references [26][27][28][29][30], respectively.…”

Section: Figure 31mentioning

confidence: 99%

“…As we can see, the RF-EH system as well as the second architecture could feed the cited sensors [26][27][28][29][30] at 22 m from relay antenna. Contrary to the first architecture, which provides a DC power lower than what theses sensors require to be turned on given that they are far from relay antenna (D > 30 m), so these sensors couldn't be powered.…”

Section: Figure 31mentioning

confidence: 99%

“…Figure 32 depicts the minimum required power supply of these sensors and the DC output power supplied by both architectures and the RF-EH system at different distances from the relay antenna. As we can see, the RF-EH system as well as the second architecture could feed the cited sensors [26][27][28][29][30] at 22 m from relay antenna. Contrary to the first architecture, which provides a DC power lower than what theses sensors require to be turned on given that they are far from relay antenna (D > 30 m), so these sensors couldn't be powered.…”

Section: Image Sensorsmentioning

confidence: 99%

See 3 more Smart Citations

A New RF Energy Harvesting System Based on Two Architectures to Enhance the DC Output Voltage for WSN Feeding

Benkalfate

Ouslimani

Kasbari

et al. 2022

Sensors

View full text Add to dashboard Cite

In this paper, a new RF Energy Harvesting (RF-EH) system for Wireless Sensor Network (WSN) feeding is proposed. It is based on two different monitored architectures using switch circuits controlled by the input powers. One architecture is more adapted to high input powers and the other to low input powers. The two different architectures and the system are designed and realized on Teflon glass substrate with a relative permittivity of 2.1 and thickness of 0.67 mm. They are tested separately as a function of the distance from the relay antenna. A new multiband antenna with a size of 40 × 30 mm2 is used for both architectures and the system. The measured antenna gains are 2.7 dB, 2.9 dB, and 2.55 dB for the frequencies of 1.8 GHz, 2.1 GHz, and 2.66 GHz corresponding to the mobile communication networks, respectively. The rectifier consists of two Schottky diodes forming a full-wave rectifier and voltage doubler. The maximum measured RF-to-DC conversion efficiency is 71.5%. The proposed RF-EH system provides a maximum DC output voltage of 5.6 V and 3.15 V for an open and 2 kΩ resistance load, respectively.

show abstract

Section: Gas Sensorsmentioning

confidence: 99%

Section: Figure 31mentioning

confidence: 99%

Section: Figure 31mentioning

confidence: 99%

Section: Image Sensorsmentioning

confidence: 99%

See 2 more Smart Citations

A New RF Energy Harvesting System Based on Two Architectures to Enhance the DC Output Voltage for WSN Feeding

Benkalfate

Ouslimani

Kasbari

et al. 2022

Sensors

View full text Add to dashboard Cite

show abstract

“…Sputtering technique was used to deposit the sensing material SnO 2 to sense the various gases. The researchers were used the supply voltage about 2 V to 3 V and the power consumed by the sensor was about 3.03 mW [88]. The researchers were studied the effect of stress in MOx material and the finite element method was used for the analysis [89].…”

Section: Recent Trends On Mems Based Gas Sensing Technologymentioning

confidence: 99%

Strategic report on MEMS based carbon monoxide sensor technology for environmental air quality monitoring using unmanned aerial vehicle

2022

IJATEE

View full text Add to dashboard Cite

Design and analysis of dual working area micro-hotplate based on thermal crosstalk

Yang,

Wei,

Jiao

et al. 2024

Microsyst Technol

View full text Add to dashboard Cite

A Novel Low Power Hexagonal Gas Sensor Cell for Multi-Channel Gas Detection

Cited by 9 publications

References 8 publications

A New RF Energy Harvesting System Based on Two Architectures to Enhance the DC Output Voltage for WSN Feeding

A New RF Energy Harvesting System Based on Two Architectures to Enhance the DC Output Voltage for WSN Feeding

Strategic report on MEMS based carbon monoxide sensor technology for environmental air quality monitoring using unmanned aerial vehicle

Design and analysis of dual working area micro-hotplate based on thermal crosstalk

Contact Info

Product

Resources

About