A Novel Image Processing Technique for Analyzing Wear Worn Surface Roughness and Corrosion Behavior of Sintered Mg/B4C Composites

Murugesan, K.; Suresh, S.; Vettivel, S.C.; Prema, C. Emmy; Jesuthanam, C. P.

doi:10.1007/s12666-020-02123-3

Cited by 4 publications

(2 citation statements)

References 41 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…therefore, it is conferment that the material has high strength with an increase in reinforcement material compared to pure alloy. the same trends have been noted by many other researchers [12,21,25].…”

Section: Ae Report On 3d Profile Graph and The Changes In Amplitudesupporting

confidence: 88%

See 1 more Smart Citation

Archives of Metallurgy and Materials

2022

View full text Add to dashboard Cite

Influence of AcoustIc emIssIon sIgnAls And dAmAge AnAlysIs durIng the tensIle test on Al8011 hybrId composItes by stIr cAstIng methodMetal network compounds have primary properties. the use of lightweight and low vitality is a testament to the growing interest in the automotive industry. aluminum alloys, due to their advanced physical, mechanical and tribological properties, have become a highly emerging material for a variety of industrial applications and the importance of efficient material selection is explained. in this paper, an al8011 hybrid metal matrix composite is developed through the stir casting process. the different weight proportions of B 4 C (3%, 6%, 9% & 12%) and fixed proportions of 2% MoS 2 have been used. Composite developed are subjected to mechanical properties evaluation and seawater corrosion studies following standard procedures. to study the porosity of the composite samples, theoretical density and actual density are calculated. an acoustic emission system-assisted tensile test is carried out to report the strength of the composite. From this experimental method, adding reinforcement can increase the tensile strength and hardness of the composites. under sea water, the increase in reinforcement found an increase in corrosion resistance. Fractured surfaces were perused using SeM and eDS analysis.

show abstract

Section: Ae Report On 3d Profile Graph and The Changes In Amplitudesupporting

confidence: 88%

“…the variation in object fracture is confirmed by the signal produced during the mechanical loading. the signals will be in the form of waves developed at a local (fracture zone) due to transient energy [25]. the schematic illustration of the ae system with the utM test machine is shown in Fig.…”

Section: Acoustic Emission Testingmentioning

confidence: 99%