A Novel Canning Technology for Forging of Gamma-TiAl Alloys

Abstract

A novel canning technology to forge gamma-TiAl alloys was developed at the BTU Cottbus. A TiAl specimen was encapsulated with multilayer stainless steel foil and glass. The steel foil layers prevented the heat loss through radiation and the glass layer reduced the temperature decrease through conduction. First, the effect of steel foil on the cooling rate was investigated. Cooling curves were recorded for TiAl specimens without steel foil layer, with 1, 2, 3 and 4 layers of steel foil, as well as with 3 coated steel foil layers, respectively. While the unprotected specimen cooled from 1200 °C to 1100 °C within 12 s, the specimen with 3 coated steel foil layers needed 52 s for the same temperature decrease. The efficiency of the glass layer was examined with forging of steel specimens. The cooling rate during forging of the specimen with a glass layer was only half of that without a glass layer. Based on the results, Ti-45Al-0.5Mo-0.5Cu-0.2Si specimens, canned with steel foil and glass, were successfully forged at strain rates of 0.1 s-1 and 0.04 s-1 with warm dies which were heated to 500 °C. Visual and metallographic examinations revealed no cracks, pores or micropores. The microstructures are fine-equiaxed grains.

Optimizing the Turning of Titanium Aluminide Alloys

“…The alloy brittleness [9][10] is a problem to be considered, in TNB and TNM material. Another point to be considered is the existence of superficial cracks, created during the turning process, which may cause the failure of this material.…”