A new method for processing algorithm to recognition of the profile of micro-mills

Abstract

Modern methods of control geometry parameters of cutting tools often incorporate measuring operations performed using high-precision CCD cameras which work on the contrast-detection method. The key advantages of this method are the high speed of measurements, the simplicity of using general method on modern CNC measuring systems and a wide range of possibilities for controlling prole locations of surfaces. However, using this method largely depends on the resolution of the camera's ability and the size of the controlled area, which in turn imposes signicant restrictions on the measurement of surface areas which are less than 10% of the frame area. This paper proposes a new way to measure the area of prole section of microtool surfaces, based on the identifying of a focused area throughout the entire frame area. This method makes it possible to recognize the nature of the focus distribution at dierent camera positions, which in turn makes it possible to measure the area of prole section of microtool surfaces when the size of the controlled area is less than 10% of the frame size to use the contrast autofocus method to incomparably increase.