A Model-Driven Domain-Specific Scripting Language for Measurement-System Frameworks

Arpaïa, Pasquale; Fiscarelli, Lucio; Commara, Giuseppe La; Petrone, Carlo

doi:10.1109/tim.2011.2149310

Cited by 14 publications

(6 citation statements)

References 26 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…So the new quantitative method is needed to describe the difference between them. At the same time, the certainty of the known special should be considered in the proofing, because they are collected or extracted from the exist materials related to the special domain [9] . Cooperated with fuzzy theory, the fuzzy mapping aggregation operator based on RIMER is applied to Chinese word semantic proofing system in this paper, and some components of the proofing system is updated with respect to the generalized RIMER based fuzzy aggregation operator.…”

Section: Co-published By Atlantis Press and Taylor And Francismentioning

confidence: 99%

The fuzzy mapping aggregation operator based on rimer and its application

Qiu¹,

Jian²,

Liu³

et al. 2014

IJCIS

View full text Add to dashboard Cite

A fuzzy mapping aggregation operator based on RIMER and its application in Chinese word semantic proofing system for special domain are discussed deeply in this paper. Firstly, the fuzzy mapping aggregation operator based on RIMER are introduced and followed by the corresponding fuzzy inference method. Secondly, the collection of the sensitive words and their substitutions and the soft inference are discussed mainly based on our previous achievements. Then the new flowchart of the semantic analysis and the bases and the modules in the Chinese word proofing system are illustrated subsequently. The experiment shows that it is more feasible and practical method for semantic analysis.

show abstract

Section: Co-published By Atlantis Press and Taylor And Francismentioning

confidence: 99%

The fuzzy mapping aggregation operator based on rimer and its application

Qiu¹,

Jian²,

Liu³

et al. 2014

IJCIS

View full text Add to dashboard Cite

show abstract

“…A separate motor is used to set the tension of the wire. The test software is implemented by means of the Flexible Framework for Magnetic Measurements (FFMM) [17]- [18]. The field multipoles are finally computed by the analysis procedure described above, which was implemented in Matlab T M .…”

Section: System Architecturementioning

confidence: 99%

Measuring field multipoles in accelerator magnets with small-apertures by an oscillating wire moved on a circular trajectory

et al. 2012

View full text Add to dashboard Cite

A method based on an oscillating wire for measuring the field quality in accelerator magnets with small apertures of the order of 10 mm is proposed. The wire is positioned step-bystep on the generators of a cylindrical domain inside the magnet aperture, i.e. its end-points at the stages are moved on a circular trajectory. The amplitudes of the wire's forced oscillations are measured and related to field harmonics by a suitable analytical model. In this paper, the analytical model, the measurement procedure, and the measurement system architecture of the oscillating wire method are presented. The method is validated by comparison with the standard rotating-coil system. A case study on small-aperture, permanent-magnet quadrupoles constructed for the Linac4 injector at CERN is illustrated.

show abstract

“…The multipole coefficients in (7) can be written explicitly as a sum of their real and imaginary parts: C c (9) The classical methods to measure multipoles utilize mainly rotating coils [7]. C n are computed by relating the FFT coefficients to the flux seen by the coil as a function of the rotational angle [8].…”

Section: B Theory Of the Multipole Coefficients Measurementmentioning

confidence: 99%

“…Finally, the acquisition software is implemented by means of the Flexible Framework for Magnetic Measurement (FFMM) [9].…”

Section: A) Measurement Setup and Proceduresmentioning

confidence: 99%

Magnetic field measurements on small magnets by vibrating wire systems

Arpaïa

Buzio

Perez

et al. 2011

2011 IEEE International Instrumentation and Measurement Technology Conference

Self Cite

View full text Add to dashboard Cite

A new method based on vibrating wire to measure field multipole is presented. The magnet multipoles are assessed by positioning the wire in different points on a circle inside the magnet aperture and measuring the amplitude of wire vibrations. An analytical model relates vibration amplitudes to multipoles. Results of simulation tests aimed at analyzing the model performance are reported. Preliminary experimental validation results on small permanent magnets for the new linear accelerator Linac4 at European Organization for Nuclear Research (CERN) are shown.

show abstract

A Model-Driven Domain-Specific Scripting Language for Measurement-System Frameworks

Cited by 14 publications

References 26 publications

The fuzzy mapping aggregation operator based on rimer and its application

The fuzzy mapping aggregation operator based on rimer and its application

Measuring field multipoles in accelerator magnets with small-apertures by an oscillating wire moved on a circular trajectory

Magnetic field measurements on small magnets by vibrating wire systems

Contact Info

Product

Resources

About