A miniature triple hot-wire probe for wall bounded flows

Bruns, J. M.; Dengel, P.

doi:10.1007/s003480050197

Cited by 3 publications

(1 citation statement)

References 10 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Instantaneous velocity vectors were measured in the boundary layer by means of a THWP and all components of the Reynolds stress tensor and the relevant triple correlations were determined. Details about this miniature probe and its calibration are given in Bruns & Dengel (1998). Figure 4 shows the THWP with wires arranged on the sides of an equilateral triangle when viewed from the front.…”

Section: Experimental Facility and Measuring Techniquesmentioning

confidence: 99%

An experimental investigation of a three-dimensional turbulent boundary layer in an ‘S’-shaped duct

1999

Self Cite

View full text Add to dashboard Cite

This paper describes the evolution of an incompressible turbulent boundary layer on the flat wall of an ‘S’-shaped wind tunnel test section under the influence of changing streamwise and spanwise pressure gradients. The unit Reynolds number based on the mean velocity at the entrance of the test section was fixed to 106 m−1, resulting in Reynolds numbers Reδ2, based on the streamwise momentum thickness and the local freestream velocity, between 3.9 and 11 × 103. The particular feature of the experiment is the succession of two opposite changes of core flow direction which causes a sign change of the spanwise pressure gradient accompanied by a reversal of the spanwise velocity component near the wall, i.e. by the formation of so-called cross-over velocity profiles. The aim of the study is to provide new insight into the development of the mean and fluctuating flow field in three-dimensional pressure-driven boundary layers, in particular of the turbulence structure of the near-wall and the cross-over region.Mean velocities, Reynolds stresses and all triple correlations were measured with a newly developed miniature triple-hot-wire probe and a near-wall hot-wire probe which could be rotated and traversed through the test plate. Skin friction measurements were mostly performed with a wall hot-wire probe. The data from single normal wires extend over wall distances of y+ [gsim ] 3 (in wall units), while the triple-wire probe covers the range y+ [gsim ] 30. The data show the behaviour of the mean flow angle near the wall to vary all the way to the wall. Then, to interpret the response of the turbulence to the pressure field, the relevant terms in the Reynolds stress transport equations are evaluated. Finally, an attempt is made to assess the departure of the Reynolds stress profiles from local equilibrium near the wall.

show abstract

Section: Experimental Facility and Measuring Techniquesmentioning

confidence: 99%